Parts for Lg LMVM2075SB / ABKELGA: Section 3 Parts

This truss head tapping screw secures panels, brackets, and covers in your appliance. Replacing a missing or damaged fastener restores a snug fit, reduces vibration, and helps keep components properly aligned for reliable performance.

• Provides low-profile holding power; wide truss head helps secure thin panels and trim
• Replaces lost, stripped, or corroded screws at the original mounting points
• Helps eliminate rattling, vibration, or loose handles/covers
• Addresses situations where a screw will not tighten or backs out during use

• Disconnect power; shut off water/gas if applicable before servicing
• Align parts and hand-start threads to avoid cross-threading
• Tighten until snug; do not overtighten to prevent stripping
• If the receiving hole is damaged, for repair before installing the new screw

This factory fastener secures appliance panels and components. Use it to replace a missing, stripped, or corroded screw so brackets, covers, and assemblies stay tight and properly aligned, helping reduce vibration and rattling.

• Secures panels, brackets, and internal components in their proper positions
• Replaces missing, worn, or cross-threaded hardware
• Helps eliminate vibration and rattling from loose parts
• Supports proper alignment of covers and assemblies

• Disconnect power to the appliance before servicing; allow any moving parts to stop
• Match this screw to the location shown in your model's parts diagram
• Start threads by hand to avoid cross-threading, then tighten snugly with the correct driver
• Do not overtighten to prevent stripping threads or cracking plastic bosses

This replacement screw secures panels, trim and internal components to restore a tight fit and stop rattling or loose parts. Use it when a missing or stripped screw causes panels or controls to shift. What it does:

• Secures panels, trim pieces or mounting brackets to keep components aligned
• Stops rattling, vibration noise or loose-fitting panels
• Replaces missing or stripped screws to restore proper fastening
• Helps ensure other parts stay in position during normal use

• Disconnect power before working on the appliance to prevent shock or injury
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and tighten until snug; avoid overtightening which can strip threads or crack plastic
• Replace with the exact OEM screw if available to ensure proper fit and function

Color: metallic. Measures about 15 inches wide by 8 inches deep.

Color: metallic. Measures about 15 inches wide by 8 inches deep.

Replace a burned-out microwave cooktop light with this halogen bulb. It restores bright, reliable illumination under your over-the-range microwave so you can see your cookware and workspace while cooking or as a night-light.

• Provides lighting for the cooktop/work area beneath the microwave
• Restores illumination when the original bulb is burned out, dim, or flickering
• Operates with the microwave's light switch/settings
• Common symptoms: no light or intermittent/flickering light

• Disconnect power at the breaker and allow the old bulb to cool before servicing
• Access the lamp from the bottom of the microwave; remove the lens/cover as designed
• Avoid touching the glass with bare hands—use gloves or a clean tissue
• Test the light before reinstalling the cover; inspect the socket or switch; do not access internal components due to stored high voltage