Parts for Roper 1116W0A: 03 - Section Parts

Secures the igniter to the burner assembly in gas ranges and ovens. Replace if stripped, missing, or damaged during igniter replacement or repair.

Replacement mounting screw for cooktops and ranges. Secures burner components, brackets, or panels. Needed when screws are stripped, lost, or damaged.

This lockwasher secures fasteners and helps prevent nuts or bolts from loosening under vibration, keeping appliance components held firmly in place. A simple replacement to restore proper mechanical retention. What it does:

• Fits over a bolt or stud to lock a fastener in place and resist loosening from vibration
• Commonly used where a secure, vibration-resistant connection is required
• Can reduce noise and wear caused by loose hardware
• Helps maintain proper alignment and assembly of moving parts

• One lockwasher

• Use the specified bolt/nut and torque per the appliance manufacturer; do not overtighten
• Replace any damaged or corroded mating hardware for best results
• Disconnect power to the appliance and follow safety precautions before servicing

This replacement back-right gas tube routes gas from the valve to the rear burner for proper combustion. It restores the correct gas flow path so the burner can light and maintain a steady flame when installed correctly. What it does:

• Directs gas from the valve to the back-right burner for ignition and operation
• Helps achieve a stable, even flame at the rear burner when functioning
• Replaces damaged, bent, or corroded tubing that can disrupt gas flow
• Can resolve symptoms like weak or no flame at the rear burner and uneven heating

• One back-right gas tube

• Turn off gas supply and power before attempting any service
• Inspect fittings and gaskets; replace any worn seals to prevent leaks
• Tighten connections to manufacturer torque specs and test for leaks with a soap solution or gas leak detector