Parts for Ge RGB744WET1WW: 04 - Section4 Parts

Replacement oven rack for electric and gas ranges. Installs inside oven cavity. Needed when original rack is missing, damaged, or warped from use.

Slotted grid that rests over the broiler pan to support food during broiling. Replace if cracked, warped, worn, or missing to restore proper function.

This metal grip allows you to safely pull out the broiler drawer for loading and unloading food. Located on the front of the broiler drawer beneath the oven, replace it if the handle is loose, broken, or becomes too hot to touch during use.

Includes 12 washers.

Includes 12 washers.

Outer oven door glass. Color: White

Seals the gap between oven door and body to retain heat during cooking. Replace if cracked, worn, or heat escapes. Verify fit with your model number.

This speed nut is a clip-on fastener that provides threads for a screw on the appliance. It secures sheet-metal panels, brackets, or trim and helps keep assemblies tight under vibration and repeated use.

• Provides captive threads so a screw can tighten into thin sheet metal
• Helps secure panels, brackets, and trim pieces in place
• Replace if a screw spins without tightening, a panel rattles/feels loose, or the original clip is missing or damaged
• Restores a snug, reliable attachment point without a loose nut

• Disconnect power and, if applicable, shut off gas; allow the appliance to cool before servicing
• Note the clip's orientation; slide it onto the panel edge or stud as designed
• Start the screw by hand to avoid cross-threading; do not overtighten
• Wear cut-resistant gloves when handling sheet-metal parts

Includes 12 screws.

Insulation layer that installs inside your range door. Replace if the original is torn, compressed, missing, or damaged to restore proper door insulation.

Protective insulation guard for your range. Installs to shield internal components. Replace if cracked, damaged, or missing to maintain proper insulation.

Replacement drawer glide for range bottom drawer. Needed when glide is broken, cracked, or snapped, causing drawer to fall, scrape floor, or not slide.

Secures the lower storage drawer assembly to your range cabinet. Replace this stamped metal bracket if cracked, bent, or missing to restore alignment.

Replacement mounting screw for range panels, brackets, and trim. Restores secure fit when original fastener is missing, stripped, or damaged.

Replace cracked, rusted, or chipped trim at the bottom of your range oven door. Installs with screws (sold separately) after removing the door.

Replacement mounting screw for electric and gas ranges. Secures internal components and panels. Needed when original screws are stripped, missing, or lost.

Replace a cracked, warped, or missing heat deflector shield on your range. This protective guard installs near heating elements to direct heat properly.

This part has been discontinued and is no longer available.

Right-side white door end cap for range oven doors. Covers outer door edge and provides secure mounting for trim. Replace if cracked, loose, or missing.