Parts for Ge WSM2420SDZWW: 11 - Section11 Parts

This oil seal keeps appliance shafts and bearings sealed to prevent oil leaks and maintain smooth operation. It helps protect internal components and reduces the risk of lubricant loss that can cause noise or premature wear. What it does:

• Seals the shaft to keep oil and lubricant inside gearboxes or motor housings
• Helps prevent oil leaks that can stain belts, drums, or surrounding parts
• Maintains proper lubrication to reduce noise and wear on rotating components
• Commonly replaced when seals are cracked, hard, or leaking

• Disconnect power before servicing and follow all safety instructions for your appliance
• Inspect mating surfaces and bearing condition; replace damaged components as needed
• Use proper tools to press the seal evenly without distorting the lip
• Verify correct orientation of the seal during installation

Spin tube bearing supports smooth washer drum rotation. Replace if you hear grinding noises or notice wobbling during spin cycles. Verify fit with your model.

This sleeve cam is a small replacement cam bushing that positions and guides the cam shaft for smooth part movement. It restores proper alignment and reduces binding or excess wear where the cam rides. What it does:

• Replaces a worn or damaged cam sleeve that lets the cam shaft turn or slide smoothly
• Helps stop squeaking, grinding, or rough movement caused by a worn cam area
• Restores proper part alignment to prevent premature wear on mating components
• Used where a cam needs a low-friction, protective sleeve to maintain correct operation

• One sleeve cam (quantity: 1)

• Disconnect power (and gas if applicable) before beginning any repair
• Access and removal steps vary by model; refer to the appliance service manual for disassembly guidance
• Inspect mating shaft and housing; clean debris before installing the new sleeve to avoid premature wear
• If fasteners or clips are damaged during disassembly, replace them to ensure secure reassembly