Parts for Lg DLEC733W / AOWEEUS: Section 4 Parts

A small flat metal washer used to space or secure fasteners in the washer's internal assemblies. Helps maintain proper part alignment and reliable fastening so components stay secure during operation. What it does

• Provides a flat bearing surface to distribute clamp load from a nut or bolt
• Acts as a spacer to set proper clearance between parts
• Helps reduce loosening and wear at fastener joints
• Commonly replaced when hardware is loose, rattling, or shows visible wear

• Disconnect power and water before servicing the appliance.
• Install with the correct bolt/nut and torque per the service manual; replace any damaged fasteners.

This outer cabinet provides the main exterior enclosure for the appliance, protecting internal components and giving the unit its finished appearance. Restores original fit and function when the outer housing is dented, cracked, or damaged. What it does:

• Replaces the appliance's outer enclosure to protect internal parts from dust, moisture, and impact.
• Restores proper alignment of doors, panels, and control openings affected by a damaged cabinet.
• Helps eliminate rattles, sharp edges, and cosmetic damage that can interfere with safe operation.
• Matches OEM mounting points so existing brackets, seals, and trim attach correctly.

• One outer cabinet

• Power off and unplug the appliance before starting; remove any attached trim, doors, or panels per service manual.
• Retain and reuse original screws, brackets, and insulation unless damaged; verify gasket/seal condition during reassembly.
• Minor alignment adjustments may be needed to ensure doors and controls sit flush.

This customized screw secures appliance panels and components for a reliable fit and safe operation. Use it to replace a missing or damaged fastener and restore proper assembly without needing a full component rebuild. What it does:

• Fastens trim, panels, brackets or small internal components to maintain proper alignment
• Restores lost or stripped fasteners that cause rattling, loose parts, or gaps
• Matches OEM fit for secure, vibration-resistant fastening when replaced correctly
• Helps prevent damage from loose components that can affect performance or safety

• Disconnect power and unplug the appliance before starting any work
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug—do not overtighten to prevent thread or component damage
• Keep removed screws organized to ensure correct reassembly

This thermostat assembly is a temperature-controlled switch for the dryer's heating circuit. It helps regulate internal air temperature to prevent overheating and maintain consistent drying performance. Replacing a failed thermostat restores proper heat control. What it does:

• Monitors and controls drum/exhaust air temperature during cycles
• Opens/closes electrical contacts to cycle the heater on and off
• Helps prevent overheating and protects other heat-related components
• Common failure symptoms include no heat, overheating/shutting off, or long dry times

• Includes: 1 thermostat assembly

• Disconnect power; for gas models, also shut off gas supply before service
• Access the thermostat per your model's service instructions; note wire locations before removal
• Move wires one-by-one to the new part and secure mounting screws firmly
• After replacement, verify proper airflow/venting to prevent repeat temperature issues