Parts for Ge DDG7289RALWW: 01 - Section1 Parts

This mini-manual ice maker assembly replaces a failed ice maker to restore ice production in compatible refrigerators. It produces, harvests and dispenses cubes on a simple mechanical cycle for straightforward repairs. What it does:

• Cycles to fill, freeze and harvest ice cubes on a manual-reset/mechanical-style mechanism
• Replaces a worn or non-working ice maker that stops producing ice or only makes a few cubes
• Helps resolve intermittent fill failures or harvest issues when the control module is faulty
• Can stop leaks caused by a malfunctioning ice maker fill/harvest sequence

• Disconnect power and shut off the water supply before beginning any repair
• Handle the ice mold carefully to avoid damage; align mounting tabs and connector before securing
• Reconnect the water line and test for leaks after installation; run one or two harvest cycles to confirm operation

This part has been discontinued and is no longer available.

The Knob Clip is an OEM part for GE washing machines and dryers. This small but crucial component is designed to secure the control knob to the appliance's control panel.  

Over time, knob clips can wear out or break due to frequent use or accidental damage. When this happens, the control knob may become loose, fall off easily, or fail to engage the control panel properly, making it difficult to set the appliance to the desired cycle or function.

Symptoms of a bad Knob Clip include:

• The control knob is loose or falls off the panel easily.
• Difficulty in adjusting settings due to a loose knob.
• The knob does not stay in place or slips when turned.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

This dryer motor kit powers the drum and blower. Replacing a weak or failed motor restores proper tumbling and airflow so the dryer starts reliably and dries loads more evenly.

• Drives the drum via the belt and turns the blower wheel for airflow
• Helps resolve: dryer hums but won't start, drum won't turn, or stops mid-cycle
• Can reduce loud buzzing/grinding noises from the motor area
• Restores consistent operation when the motor overheats and trips its protector

• Disconnect power; turn off gas supply to gas dryers before servicing
• Remove panels to access the drive system; release belt tension and remove the drum as needed
• The blower wheel threads onto the motor shaft—support it carefully; many GE dryers use a reverse (left-hand) thread
• Transfer wiring and any reusable hardware to the new motor; test before reassembly

Size: 8-32 t. Includes 12 screws.

Package of 12