Parts for Ge TA10SPB: 01 - Section1 Parts

The R134 Drier is an OEM part for GE refrigerators. This component plays a critical role in the refrigeration system by removing moisture and contaminants from the refrigerant, ensuring efficient cooling and preventing damage to other parts of the system. It helps maintain the purity and effectiveness of the refrigerant as it cycles through the system.

You should replace the R134 drier if it becomes clogged or damaged. Common causes of a bad drier include wear and tear over time, exposure to moisture, or contamination from other failing components in the refrigeration system.

Symptoms of a bad R134 drier include:

• Reduced cooling efficiency
• Frost buildup on the evaporator coils
• Unusual noises from the refrigeration system
• Increased energy consumption
• Refrigerator not maintaining the set temperature

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This left-side refrigerator door stop cushions and limits door travel to prevent over-rotation and reduce wear on hinges and gaskets. It helps doors close smoothly and protects cabinet edges from impact. What it does:

• Stops and cushions the left door to prevent over-rotation and damage
• Helps maintain proper door alignment for reliable sealing
• Reduces loud bangs or sudden slams when opening or closing the door
• Fits into the hinge/stop location to absorb normal door movement

• One left door stop

• Unplug the appliance or shut off power before beginning service
• Remove the door or access panel per your model's service instructions if needed for clearance
• Replace the stop in the hinge/stop pocket and secure per OEM guidance; reuse existing fasteners unless replacements are specified

A replacement mounting screw used to secure appliance components and panels. Replaces a lost or stripped fastener so parts stay properly attached for safe, quiet operation. What it does:

• Secures trim, panels, brackets, or internal components to maintain proper alignment
• Helps stop rattling or vibration caused by a missing or loose fastener
• Restores a proper connection after repairs or part replacements
• Matches OEM fit to ensure correct engagement with original threaded holes

• Use the correct screwdriver or bit to avoid stripping the head
• Hand-start the screw to ensure proper thread alignment before final tightening
• Do not overtighten; snug until secure to avoid cracking plastic or damaging threads
• Disconnect power or follow appliance safety procedures if working near electrical components