Parts for Ge TBE16SATDRWH: 01 - Section1 Parts

Assembly screw kit for refrigerators. Secures handles, shelf tracks, door hinges, and interior panels. Replace missing, stripped, or lost screws.

Replaces cracked, broken, or missing end caps on refrigerator door shelf supports. Snaps onto shelf bar ends for a finished look and secure fit.

Covers and secures the ends of refrigerator door shelves and bins. Replace if cracked, broken, or missing to restore a finished look and prevent items from sliding off.

Freezer door gasket creates an airtight seal to keep cold air in. Replace when cracked, torn, or door won't seal properly. Verify fit by model number.

Includes 12 screws. Size: 8-18 ab.

Replace your refrigerator door gasket when you notice condensation, warm spots, or air leaks. Creates an airtight seal to maintain temperature. Verify fit.

Color: white. It measures about 12 inches wide by 6 inches high.

Reversible door plug fills unused mounting holes when switching refrigerator door swing direction. Replaces broken or missing plugs for a finished look.

Retainer strip for refrigerator shelves and bins. Secures components in place and prevents shifting. Replace if cracked, broken, or missing for proper fit.

This small decorative cap covers screws that secure the refrigerator door handle, maintaining a clean appearance. Located over handle mounting points, replacement is needed when caps are missing, cracked, or discolored.

Donut-shaped gasket creates a tight seal between refrigerator components. Replace when worn to stop minor leaks and restore secure fit. Verify fit with your model number.

This is a grommet and gasket assembly that seals the ice maker water fill tube where it passes through the freezer wall. It prevents warm air from entering the freezer compartment and stops moisture from building up around the fill tube opening. Replace this assembly if you notice frost or ice buildup around the fill tube entry point, water leaking near the ice maker, or if the existing grommet is cracked or deteriorated.

2 wire insulator.

Replacement screw for refrigerators. Secures handles, panels, and internal components. Order if yours is missing, stripped, or lost during repairs.

Secures refrigerator wiring to prevent chafing and vibration noise. Replace when damaged or missing to keep harnesses organized. Confirm fit by model.

Supplies electrical power from wall outlet to refrigerator. Replace this cord if cut, frayed, overheated, or damaged to restore safe electrical connection.

Replacement mounting screw for securing panels, trim, and internal components in appliances. Needed when original screws are stripped, lost, or damaged.

Size: 10-12 x 1/2 inch.

This plug button is a small snap-in cap used on refrigerators to cover exposed holes on door handles, liners, or trim. It restores a clean, finished look while helping keep dust and moisture out of the cabinet.

• Snaps into a screw or access hole on a handle, liner, or trim panel
• Covers fasteners and gaps for a clean, finished appearance
• Helps block dirt and moisture from open holes
• Typical symptoms: missing cap, broken or loose plug, visible screw hole or cosmetic gap

• Unplug the appliance before servicing and use caution around sharp edges
• Align the plug with the hole and press straight in by hand until fully seated and flush
• For handle screw holes, tighten fasteners first, then install the cap
• Avoid using metal tools on finished surfaces to prevent scratches