Parts for Kitchenaid KCDC150G1: 01 - Section Parts

This stopper assembly seals the drain opening to allow tubs or sinks to fill and hold water. It replaces a damaged or worn stopper so you can restore proper fill-and-hold function and stop unwanted leaks. What it does

• Seals the drain to hold water for washing or soaking
• Opens and closes to allow controlled draining when needed
• Stops water from leaking around a worn or damaged stopper
• Restores normal fill-and-drain operation when the original stopper no longer seals

• One stopper assembly as shown

• Turn off water supply and remove standing water before starting
• Basic hand tools usually required; follow the appliance or sink manufacturer instructions
• Inspect surrounding drain and seals during replacement; replace damaged gaskets if present

This disposer flange kit secures a garbage disposer to the sink and helps create a watertight seal at the sink opening. It replaces worn or damaged mounting parts to stop leaks and stabilize the disposer. What it does

• Provides the sink-side flange and mounting components that hold the disposer to the sink
• Creates a watertight barrier between the sink and disposer to reduce leaks
• Restores a secure connection if the existing flange is corroded, cracked, or loose
• Works with standard sink openings and common disposer mounting assemblies

• Disconnect power to the disposer and turn off water/dishwasher connections before starting.
• Remove the old flange and clean the sink opening; use plumber's putty or listed sealant per the disposer/OEM instructions if required.
• Reinstall the flange and tighten the mounting ring evenly to seat the gasket; confirm a secure fit before restoring power or water.

This mounting gasket creates a tight, cushioned seal where a component attaches to its housing or bracket. Replacing a worn seal helps stop leaks and rattles while restoring a secure, reliable connection at the mounting point.

• Forms a seal between two mounting surfaces to help prevent leaks or seepage
• Cushions and isolates vibration for quieter operation
• Helps maintain proper alignment of the mounted component
• Replace if the gasket is cracked, flattened, brittle, or no longer sealing

• Disconnect power and shut off water or gas, if applicable
• Note the gasket's orientation before removal
• Clean and dry both mating surfaces; remove all old gasket material and residue
• Seat the new gasket evenly; reassemble and tighten fasteners snugly without overcompressing; test for leaks/operation