Parts for Thermador PRD486EDG01: Small Oven Parts

The temperature sensor is an electronic probe that monitors internal appliance temperature and reports it to the control so it can regulate operation. Replacing a failed sensor restores more accurate temperatures and can clear temperature-related error codes. What it does:

• Senses internal temperature via resistance changes and sends the signal to the electronic control
• Helps the control reach and maintain the set temperature during operation
• Common failure symptoms: too hot/cold, won't reach set temp, long/short cycles, temperature error codes
• Can cause preheat to stall or the unit to shut off early (model dependent)

• Includes: 1 temperature sensor

• Disconnect power at the breaker before servicing
• Location and access vary by model; typically mounts with screws or a clip and connects to a 2-wire harness
• Handle the connector and wiring carefully; route and secure away from hot or moving parts
• After installation, clear stored errors and run a test cycle to proper readings

Heating element assembly that restores your appliance's ability to heat water or air so cycles reach the correct operating temperature. Use it to replace a failed heater that prevents proper drying, sanitizing, or heating performance. What it does:

• Heats water or air during operation so wash, sanitize, and dry cycles reach the intended temperature.
• Common repair for no-heat, poor drying, or cycles that fail to reach or maintain temperature.
• Works with the appliance's control and thermal cutoff to deliver regulated heat when called for.
• Replace if the element is visibly damaged, shows an open circuit on a multimeter, or triggers thermal faults.

• Always disconnect power (unplug or switch off breaker) before servicing the appliance.
• Handle carefully; terminals and mounting brackets can be sharp or fragile. Avoid bending element tubing.
• After installation, restore power and run a short diagnostic or cycle to confirm proper heating and no error codes.

This genuine dishwasher tub heating element warms wash water and helps dry dishes by raising cycle temperatures. It's a direct-replacement part for Bosch dishwashers that restores proper wash and drying performance when the heater fails. What it does:

• Heats wash water so detergent cleans effectively and soils are removed
• Assists in the drying phase by raising interior temperature for better evaporation
• Commonly replaced when the dishwasher does not heat, leaves dishes wet, or shows related cycle faults
• Works as the primary thermal element for the dishwasher's wash/dry functions

• One heating element

• Disconnect electrical power at the breaker before starting any work
• Replace only with the exact part specified for your model; handle ceramic/metal elements carefully to avoid damage
• Inspect and reseat gaskets and mounting hardware; ensure connections are tight and wires are undamaged
• After installation, restore power and run a short cycle to ensure proper heating and operation