Statesman Tiller Parts

Replacement carriage bolt for lawn mowers and tillers. Secures components to frame and housing. Replace when bolt is stripped, missing, or damaged.

Hex nut for securing components on outdoor power equipment. Replace when threads are stripped, nut is corroded, or hardware is missing or damaged.

Square key for lawn tractors, tillers, and snow blowers. Secures shafts and pulleys. Replace if worn, sheared, or missing to restore proper assembly.

If your tiller has grinding noises or won't engage properly, this 16-tooth spur gear restores smooth transmission operation. Common repair part.

This is a vinyl-plastic grip that slides over the handle bar of a snowblower. It provides a comfortable, non-slip surface for controlling the machine during operation. Replace this grip if it has become cracked, torn, or too loose to stay securely on the handle.

This genuine OEM part is a compression spring for a lawnmower. The compression spring is the spring that holds the mower deck onto the lawnmower. Over time, the compression spring can become degraded due to excessive wear and tear. If it is no longer securing the mower deck, it will need to be replaced. Luckily, replacing this part is a relatively simple process.To replace the spring, make sure the mower deck is set to the lowest position. Locate the old retainer spring and pull it out and away from the mower. Once removed, slide the new spring into its proper position. Make sure it fits tightly, and the mower deck is secured. Once secured, power the mower to see if the spring stays in place during operation. If it does, then the installation was a success. This replacement part is sold individually and is compatible with MTD brand lawnmowers.

Small metal washer for lawn mowers and outdoor power equipment. Replaces cracked, worn, or missing washers. Ensures proper spacing and assembly.

Replace a bent, damaged, or broken tiller shaft causing poor tilling performance or unusual vibration. Direct fit for multiple rear-tine tiller models.

This is a metal connecting rod that attaches the rear debris guard to the tiller frame, keeping the guard properly positioned during operation. It ensures the guard stays in place to deflect dirt and debris kicked up by the tines. Replace this rod if it is bent, broken, or missing, which can cause the rear guard to hang loosely or fall off during use.

Replace a broken or worn input shaft assembly causing power transmission issues in your tiller. Restores proper drive function. Moderate repair difficulty.