Parts for Ge ZDP36L6H4SS: 06 - Structure Parts

This is the hinge receptacle that mounts to the oven frame and receives the door hinge, allowing the oven door to pivot open and closed. It provides a secure anchor point for the hinge pin or arm. Replace this receptacle if the oven door is sagging, not closing flush, or if the mounting point is cracked or worn.

Replacement hex head screw for your range. Secures internal components and panels. Order a new screw if yours is stripped, missing, or damaged.

This landing edge kit replaces the worn or damaged landing edge on compatible GE appliances to restore a secure, even door or panel fit and reduce drafts or rubbing. Designed as a direct-fit service part for affected models. What it does

• Replaces the landing edge strip that provides a finished, cushioned contact surface for a door or panel.
• Helps stop scraping, rattling, or uneven closing caused by a worn or torn landing edge.
• Restores the proper seal/contact area to reduce air leaks and improve door alignment.
• Keeps surrounding trim from wearing prematurely by providing a consistent contact surface.

• One landing edge kit (ZDP) as shown.

• Verify accessibility and remove power from the appliance before starting.
• Clean the mounting area and remove old adhesive or remnants to ensure good fit and adhesion.
• Use appropriate hand tools; avoid sharp tools that could damage adjacent trim or seal surfaces.
• Follow any model-specific instructions in the service manual for proper positioning and attachment.