Parts for Frigidaire AR14NS8F1: 05 - System Parts

Fix an AC compressor that won't start or struggles to turn on with this start assist kit. Helps older units start reliably. DIY-friendly installation.

Front panel clip for air conditioners. Secures the front cover to the unit housing. Replace if cracked, broken, or missing to properly hold the door in place.

This part has been discontinued by the manufacturer and is no longer available.

This terminal-cover gasket seals and cushions the appliance's electrical terminal cover, helping protect wiring and connections from moisture, dust and abrasion. It restores a secure fit for the cover and helps maintain safe operation. What it does:

• Creates a sealed barrier around the terminal cover to reduce moisture and debris intrusion
• Cushions the terminal cover to prevent chafing or movement of wiring and connectors
• Helps reduce risk of arcing by keeping cover seated and terminals covered
• Useful when the existing gasket is cracked, warped, missing, or no longer forms a tight seal

• Disconnect power to the appliance before servicing electrical components
• Remove the terminal cover and clean mating surfaces of debris and old gasket material
• Press the new gasket into place, ensuring it seats evenly around the cover perimeter
• Reinstall the terminal cover and restore power; inspect for secure fit and any exposed wiring

This overload protector is a safety device mounted on the compressor that cuts power when the motor draws too much current or overheats. It prevents damage to the compressor by shutting it down before excessive heat or electrical load causes failure. Replace this part if the compressor won't start, cycles on and off rapidly, or if the unit shuts down unexpectedly during operation.

A front mounting bracket that secures the appliance's front panel or trim, helping keep panels aligned and stable for proper fit and operation. Durable replacement for worn or damaged front bracket hardware. What it does:

• Provides a secure attachment point for the front panel or trim to the appliance cabinet
• Keeps the front panel aligned to prevent gaps or rubbing during use
• Reduces vibration and rattling caused by a loose or broken bracket
• Helps restore correct door/panel fit and appearance

• Disconnect power to the appliance before starting any repair
• Use basic hand tools; support panels to avoid damage while removing fasteners
• Reinstall fasteners to manufacturer torque; check panel alignment after installation

If your air conditioner shows temperature reading errors or won't start, the thermistor holder may be damaged. This bracket secures the sensor in place.

Metal sheet-metal screw secures panels, brackets, and internal components. Replace when missing, stripped, or damaged to restore proper fit.