Parts for Kenmore 253.74106300 (25374106300, 253 74106300): System Parts

A sealed refrigeration compressor that circulates refrigerant to enable cooling in compatible refrigerators and freezers. Replaces a failed compressor to restore the system's ability to move refrigerant and maintain proper temperatures. What it does:

• Compresses refrigerant vapor so the cooling cycle can release heat at the condenser and produce cold at the evaporator.
• Stops system cycling issues caused by a mechanically failed or seized compressor.
• Helps address symptoms like warm interior temperatures, refrigerator not cooling, or frequent compressor short-cycling (when caused by compressor failure).
• Works as the central sealed motor-pump assembly in the sealed refrigeration system.

• One sealed refrigeration compressor

• Installation and sealed-system service (evacuation, recharge) are strongly recommended; handling refrigerant requires certified service tools and procedures.
• Inspect and replace damaged or contaminated drier/receiver and service valves per OEM guidance when replacing a compressor.
• Disconnect power before servicing and follow all safety and EPA refrigerant-handling regulations.

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This terminal cover gasket seals and cushions the appliance's electrical terminal cover to help block dust and moisture while providing an insulating barrier around the power connection. It's a direct-fit replacement for worn or damaged seals. What it does:

• Seals the area around the terminal cover to help keep out dust, moisture, and debris
• Cushions and positions the terminal cover to reduce vibration and contact wear
• Provides electrical insulation around the terminal area for safer operation
• Commonly replaced when the cover is cracked, deformed, or no longer seals properly

• Disconnect power (unplug or shut off breaker) before servicing electrical terminals
• Remove the terminal cover per your model's service instructions, replace gasket, and re-seat cover fully
• Inspect terminal cover and wiring; replace any cracked covers or damaged wires before reassembly

This replacement terminal cover protects the appliance's power terminal block and wiring from accidental contact and debris, restoring a safe enclosure for the live electrical connections. What it does:

• Protects the terminal block and wiring from accidental contact, dust and debris
• Helps prevent arcing, sparks or shorting caused by exposed terminals
• Secures the routing area around power connections for safer operation
• Useful when original cover is cracked, melted, missing or shows burn marks

• Always disconnect power at the breaker or unplug the appliance before servicing
• Remove access panel or back panel to reach the terminal block; reinstall cover so it fully encloses the terminals
• Use appropriate fasteners if required; ensure all wire terminals are tight and positioned before replacing the cover
• If wiring or the terminal block shows damage or corrosion, replace or repair those components before restoring power