Timberland Tractor

Shield spacer for lawn tractors and riding mowers. Provides proper spacing and alignment for protective shields. Replace if missing, damaged, or worn.

Replace your lawn mower's hex head tap screw if lost, stripped, or damaged. This small fastener secures components on mowers, tillers, and edgers.

Hex screw fastener for lawn tractors and outdoor power equipment. Secures components throughout the machine. Replace if stripped, overtightened, or missing.

Left hand wheel axle for lawn tractors. Connects wheel to drive system for steering and movement. Replace if bent, worn, or broken. Direct fit component.

Control knob for garden tractors and tillers. Mounts on control panel to operate equipment functions. Replace if cracked, broken, or missing.

This amp fuse is a genuine MTD part, sold individually. This amp fuse can be used as a replacement part in a lawn mower. The purpose of the amp fuse in a lawn mower is to protect the lawn mower from potential voltage issues and failures that might occur during the general use of the appliance.The amp fuse in a lawn mower might need to be replaced if the component suffers damage or blows out after protecting the appliance from an electrical current voltage overload. If the amp fuse has blown or has suffered damage from general wear and tear with long-term use, the amp fuse should be removed and replaced by this genuine OEM replacement part in order to guarantee continued safe use of the lawn mower by the operator. Always unplug the appliance before performing any kind of repair or replacement.This component is a genuine OEM replacement part sourced directly from the manufacturer. It is sold individually. This amp fuse is compatible with the following outdoor appliance brands: MTD, Cub Cadet, and Troy-Bilt.

Insulator plate for lawn tractors and riding mowers. Mounts between engine components to provide heat insulation and proper spacing. Replace if cracked or worn.

This genuine OEM part is a compression spring for a lawnmower. The compression spring is the spring that holds the mower deck onto the lawnmower. Over time, the compression spring can become degraded due to excessive wear and tear. If it is no longer securing the mower deck, it will need to be replaced. Luckily, replacing this part is a relatively simple process.To replace the spring, make sure the mower deck is set to the lowest position. Locate the old retainer spring and pull it out and away from the mower. Once removed, slide the new spring into its proper position. Make sure it fits tightly, and the mower deck is secured. Once secured, power the mower to see if the spring stays in place during operation. If it does, then the installation was a success. This replacement part is sold individually and is compatible with MTD brand lawnmowers.

Flat washer for lawn tractors and mowers. Replace when worn, damaged, or lost to ensure proper hardware fit and secure assembly. Verify compatibility.