Parts for Bosch HEIP054U/07: Top Assy Parts

Decorative trim plate that covers gaps between your electric range and cabinetry. Replace if cracked, broken, or missing to restore a clean finish.

Cracked or chipped cooktop surface? This glass hob top restores your range's cooking area. Seals burners from spills and provides a smooth surface.

Replace your electric range control panel indicator light when it fails to illuminate or dims. Restores cycle status visibility. Confirm fit with your model.

Burner not heating or taking too long to boil water? This heating element assembly restores proper temperature output. Common fix for cooktops and ranges.

This heating element heats and helps dry dishwasher loads by raising water and air temperature during wash and dry cycles. Replaces a failed tub heater to restore normal wash temps and drying performance. What it does:

• Warms wash water so detergent cleans effectively and food soils break down.
• Raises air temperature during the dry cycle to help evaporate moisture.
• Stops heating when defective, which can cause poor cleaning or no drying.
• Works with the dishwasher's control system to cycle heat on and off as needed.

• One heating element

• Disconnect power to the appliance before starting any repair.
• Access typically requires removing the lower access panel; keep fasteners and seals secure during reassembly.
• Inspect wiring and terminals for damage; replace or tighten connectors as needed.

Range not heating properly? This heating element restores consistent cooking temperatures. A moderately difficult repair that typically takes 30-45 minutes.

Mounting screw secures internal oven components and panels. Replace if stripped, missing, or damaged during service. Essential hardware for reassembly.

A single electrical replacement lead that restores a broken or damaged connection inside your appliance, allowing a circuit or component to regain reliable power and operation. What it does:

• Carries electrical current between components to complete appliance circuits
• Replaces frayed, cut, or burnt wiring that causes intermittent power or failure
• Helps stop arcing, sparks, or loose-connection symptoms when installed correctly
• Restores a specific circuit path so affected features or a component can function again

• Disconnect power to the appliance before inspecting or replacing wiring
• Match the wire routing, length, and terminal connections exactly to the original
• Use correct crimping or soldering and proper insulation to prevent shorts

This cable harness routes electrical signals between dishwasher components to restore proper control and power delivery. It replaces a damaged or broken wiring assembly so affected circuits can communicate and operate reliably. What it does:

• Connects control board, sensors, pumps and other internal components to carry power and signals
• Restores intermittent or lost power to specific assemblies caused by frayed or broken wires
• Helps eliminate error codes or failures tied to open or shorted harness connections
• Prevents arcing and poor connections that can cause unreliable operation

• One cable harness assembly as pictured

• Only install after disconnecting power to the appliance to avoid shock or damage
• Inspect mating connectors and pins for corrosion or damage before connecting
• Route harness away from sharp edges, moving parts and hot surfaces to avoid future wear

Fix intermittent power or electrical faults in your range with this cable harness. Routes power and signals between control and components. Direct fit.