Parts for Maytag MGDB850WB1: 01 - Top And Console Parts

Electronic Sahara control board that manages cycle selection, timing and the user interface. Replaces a failed control to help restore responsive controls and correct cycle operation when the dryer exhibits unresponsive buttons, error codes, or won't start. What it does:

• Regulates cycle selection, timing and control signals for the appliance
• Manages start/stop inputs, user interface feedback and cycle sequencing
• Common symptom part: unresponsive touchpad/buttons, blinking lights or error codes

What's included: One electronic control board. Install notes:

• Always disconnect power before servicing the appliance
• Access requires removing the control console or panel; keep fasteners organized
• Handle the board by the edges and avoid static discharge; transfer any overlays or mounting hardware if required

Screw for control panel.

This self-drilling screw secures appliance panels and components where a fastener must cut its own pilot hole. It provides a quick, reliable hold for repair or reassembly of trim, brackets, and internal fixtures. What it does:

• Fastens panels, brackets, and small components without pre-drilling
• Helps stop loose or rattling trim and parts caused by missing or worn screws
• Restores proper alignment and secure mounting after repairs
• Works where sheet metal or thin substrates require self-tapping engagement

• One self-drilling screw

• Disconnect power and follow appliance safety procedures before starting repairs
• Use the correct size driver and steady pressure to avoid stripping the head
• Start straight and apply firm, even torque; avoid overtightening which can damage mounting surfaces
• Wear eye protection and handle small fasteners carefully to avoid loss or ingestion hazards

For mating terminal use [AP31136300].

This harness clip secures appliance wiring to the cabinet or components to prevent rubbing, pinching, and interference with moving parts. It keeps wiring routed neatly for reliable operation and reduced risk of abrasion-related failures. What it does:

• Holds wire harnesses in place to prevent chafing against sharp edges or moving parts
• Reduces vibration-related noise and intermittent connections caused by loose wiring
• Helps maintain proper wire routing around panels, motors, and heaters
• Supports safe operation by keeping wires away from heat sources and pinch points

• Disconnect power to the appliance before servicing to avoid electric shock
• Remove panels or access covers as needed to reach the original clip location
• Install by snapping or seating the clip into the original mounting point and securing the harness in the retainer; replace any broken mounts
• Inspect surrounding wiring and replace damaged wires or insulation before completing repair