Parts for Whirlpool WGD8500BC0: 01 - Top And Console Parts

This is a dryer control board. This component is one of the most important in the dryer since it controls many of the important features of the appliance. For instance, it determines the time and temperature for a cycle of clothes going through the drying process. This part can be damaged over time or through regular use and may need to be replaced.If the control board is malfunctioning, it might cause the dryer to stop heating, alter cycle length, or prevent the appliance from starting at all. Start the process by making sure the dryer is unplugged. A set of tools and work gloves will be useful for the process. Unscrew and remove the top panel before disconnecting the control panel housing. The wires are connected to the control board before disconnecting them. Reattach them to the new component and reassemble the appliance.This is a dryer control board for Whirlpool appliances. It is sold as an authentic OEM replacement part that is sourced directly from the manufacturer. This part is sold on an individual basis.

This electronic control board manages a range of appliance functions and restores user-interface and cycle control when the original board fails. It replaces a faulty main control to return responsive buttons, displays, and cycle operation. What it does:

• Receives input from the console and runs the appliance's timed cycles and functions
• Powers and updates the user display and control lights for accurate status feedback
• Regulates signals to motors, valves, and heaters so selected cycles run correctly
• Common symptoms it can fix: no display or unresponsive controls, appliance won't start, or erratic cycle behavior

• One electronic control board

• Disconnect power to the appliance before attempting service to avoid shock or damage
• Handle the board by the edges and avoid touching components; ground yourself to prevent static damage
• Verify connector orientation and seating before powering up; replace any damaged harnesses or fasteners
• Test related components (sensors, harnesses, fuses) per OEM instructions

Screw for control panel.

This self-drilling screw secures appliance panels and components where a fastener must cut its own pilot hole. It provides a quick, reliable hold for repair or reassembly of trim, brackets, and internal fixtures. What it does:

• Fastens panels, brackets, and small components without pre-drilling
• Helps stop loose or rattling trim and parts caused by missing or worn screws
• Restores proper alignment and secure mounting after repairs
• Works where sheet metal or thin substrates require self-tapping engagement

• One self-drilling screw

• Disconnect power and follow appliance safety procedures before starting repairs
• Use the correct size driver and steady pressure to avoid stripping the head
• Start straight and apply firm, even torque; avoid overtightening which can damage mounting surfaces
• Wear eye protection and handle small fasteners carefully to avoid loss or ingestion hazards

This name plate is the decorative centennial badge that restores the appliance's exterior appearance and branding. It replaces a missing, damaged, or faded badge to keep the unit looking factory-finished. What it does

• Restores the appliance's exterior badge for a like-new appearance
• Replaces badges that are cracked, scratched, peeling, or discolored
• Helps identify the appliance style when the original emblem is missing
• Cosmetic part only — does not affect appliance operation

• One name plate

• For best results, clean the mounting area and remove dirt or wax before installation
• Handle carefully to avoid scratching the finish; use non-marring tools as needed
• If access behind trim is required, unplug the appliance or disconnect power before removing panels
• Follow OEM instructions for removal and reinstallation to avoid damaging clips or surrounding trim