Parts for Frigidaire 283447D: Top / Drawer Parts

The Square Gas Drip Pan is an OEM part for Frigidaire gas ranges. This component is designed to sit beneath the burner to catch spills, drips, and splatters during cooking. It measures 9” wide by 9” deep.

Symptoms of a bad Square Gas Drip Pan include:

• Heavy accumulation of burnt-on grease and food particles that can be difficult to clean.
• Rusting or corrosion that compromises the integrity of the pan.
• Warping or bending of the pan, which can affect its fit and function.
• Discoloration or severe staining that detracts from the overall appearance of the stove.

Causes of a bad drip pan can include exposure to high temperatures, acidic or sugary spills that are not cleaned promptly, and general wear and tear over time.

This OEM part is also compatible with other brands like Electrolux, Gibson, Kelvinator, and Kenmore models.

Set Of 4

This burner cap sits on top of a gas cooktop surface burner to shape and protect the flame for even heating and safe operation. It restores proper flame pattern and helps keep the burner head clean. What it does:

• Covers the burner head to direct gas flow and create an even flame
• Helps prevent food and spills from clogging the burner ports
• Can improve ignition consistency and reduce yellow or uneven flames
• Replaces cracked, warped, or missing caps that cause poor heat distribution

• One replacement burner cap

• Ensure the appliance is OFF and completely cool before servicing
• Lift off the old cap and set the new cap in the correct position on the burner head
• No special tools required; verify the cap sits flat and centered before use
• Inspect for cracks or heavy corrosion; replace if damaged

This is a replacement mounting screw used to secure the dual safety valve assembly on compatible gas ranges and ovens. It restores proper fastening so the valve stays firmly in place during operation. What it does

• Secures the safety/dual gas valve to the appliance chassis or manifold
• Prevents valve movement that can interfere with burner operation or alignment
• Commonly replaced when original screw is missing, stripped, or damaged
• Matches OEM thread size and length for correct fit and retention

• One (1) screw, size 10-16 x 0.486

• Disconnect power and shut off gas supply before starting work; follow all safety procedures
• Thread carefully to avoid cross-threading; do not overtighten — snug to OEM torque specification
• Inspect surrounding mounting holes and hardware; replace any stripped or damaged parts for a secure fit