Parts for Frigidaire FGF333BADE: 05 - Top / Drawer Parts

Replace your range's broiler channel if it's cracked, bent, or damaged. This structural component supports the broiler assembly in your oven cavity.

The Square Gas Drip Pan is an OEM part for Frigidaire gas ranges. This component is designed to sit beneath the burner to catch spills, drips, and splatters during cooking. It measures 9” wide by 9” deep.

Symptoms of a bad Square Gas Drip Pan include:

• Heavy accumulation of burnt-on grease and food particles that can be difficult to clean.
• Rusting or corrosion that compromises the integrity of the pan.
• Warping or bending of the pan, which can affect its fit and function.
• Discoloration or severe staining that detracts from the overall appearance of the stove.

Causes of a bad drip pan can include exposure to high temperatures, acidic or sugary spills that are not cleaned promptly, and general wear and tear over time.

This OEM part is also compatible with other brands like Electrolux, Gibson, Kelvinator, and Kenmore models.

This part has been discontinued by the manufacturer and is no longer available.

Color: Black. Approx. 29" long.

This is a replacement mounting screw used to secure the dual safety valve assembly on compatible gas ranges and ovens. It restores proper fastening so the valve stays firmly in place during operation. What it does

• Secures the safety/dual gas valve to the appliance chassis or manifold
• Prevents valve movement that can interfere with burner operation or alignment
• Commonly replaced when original screw is missing, stripped, or damaged
• Matches OEM thread size and length for correct fit and retention

• One (1) screw, size 10-16 x 0.486

• Disconnect power and shut off gas supply before starting work; follow all safety procedures
• Thread carefully to avoid cross-threading; do not overtighten — snug to OEM torque specification
• Inspect surrounding mounting holes and hardware; replace any stripped or damaged parts for a secure fit

Size: 10-32 x 0.312 inch. Color: Black.

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

This main wiring harness connects a refrigerator's control board to its major components so electrical signals and power reach fans, compressor and defrost elements. Replacing a damaged harness restores reliable electrical routing and component operation. What it does:

• Carries power and signal connections between the control board and refrigerator components (compressor, fans, defrost heater, sensors)
• Replaces damaged or chafed wiring that can cause intermittent operation or failure of cooling systems
• Addresses symptoms like fans not running, compressor not receiving power, or refrigeration cycles failing to start
• Helps clear wiring-related fault codes when connectors or wires are open or shorted

• Disconnect power to the appliance before beginning any repair to avoid shock or damage
• Handle connectors and terminals gently; line up keyed plugs and seat fully until they click
• Route and secure the harness to match factory clips and strain-relief points—avoid pinching or contact with sharp edges

Size: 8-18ab x 0.5 inch.

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

Size: 10-32 x 0.312 inch. Color: Black.

Size: 8-32t x 0.500 inch. Color: Black.