Parts for Frigidaire FPIF3093LFD: 09 - Top / Drawer Parts

This is a replacement drawer and door panel kit that restores the exterior appearance and function of the appliance's lower drawer and adjacent door. It fits as a direct-fit cosmetic panel kit to refresh worn or damaged fronts. What it does:

• Replaces damaged, cracked, or faded drawer and door panels to improve appearance
• Restores a flush, secure fit for the lower drawer and adjoining door
• Helps keep contents protected by providing a properly aligned front surface
• Matches OEM fit and attachment points for straightforward replacement

• Disconnect power before beginning any repairs and take care when moving heavy panels
• Installation may require removal of the drawer, trim screws, and clips; keep fasteners organized
• Use caution to avoid scratching surrounding surfaces and follow model-specific instructions

This glide is a replacement drawer slide that helps the refrigerator or freezer drawer open and close smoothly and stay aligned. It restores stable drawer movement and reduces sticking or uneven travel. What it does:

• Guides the drawer along its track for smooth, controlled opening and closing
• Keeps the drawer aligned to prevent rubbing, binding, or uneven movement
• Replaces worn or damaged glides that cause sticking, sagging, or noisy operation
• Works as a structural support point for the sliding drawer assembly

• One replacement glide

• Basic hand tools are typically all that's needed; remove the drawer to access the glide
• Compare the old glide to this part before installing to confirm fit and orientation
• Keep fingers clear of pinch points; wear gloves if needed and follow appliance power-off safety
• If fasteners are stripped or broken, replace them with OEM-equivalent hardware

This bake element is the oven's main heating element that provides consistent heat for baking and roasting. Replacing a failed element restores proper oven temperature and cooking performance. What it does:

• Heats the lower oven cavity for baking and roasting cycles.
• Common symptom: oven does not heat or reaches lower-than-set temperatures.
• Common symptom: uneven baking or food undercooks on all racks.
• Also check for visible damage, burn marks, or broken connectors.

• Disconnect power at the breaker or unplug the appliance before starting any repair.
• Allow the oven to cool fully before accessing the interior; wear gloves to protect against sharp edges.
• Remove the oven cavity access panel or back panel as required to access element mounting screws and wiring.
• Verify wiring connections are secure and test the element for continuity with a multimeter before final reassembly.

This is a range element assembly that's used in select electric ranges. It creates an electromagnetic field to help transfer energy to heat the food. Another name for this piece is an induction coil. If it is not working properly, it could prevent the burner from heating, rendering it useless.Although the range element can last for a long time, it will start to wear out and will break with extended use. Like other parts on the range, it could be damaged if the stove is moved and dropped.Unplug the range before replacing it.This range element assembly fits certain models from Frigidaire, Electrolux, and Kenmore. This piece is a genuine OEM replacement part sourced from the manufacturer. It is sold individually.

This main top assembly replaces the upper cooktop surface to restore a flat, finished work area and secure the burners and controls. It improves appearance and helps ensure proper fit of grates, burners, and control components. What it does:

• Provides the finished cooktop surface and mounting for surface burners and burner bowls
• Replaces warped, dented, chipped, or rusted cooktop tops that no longer seat grates or elements correctly
• Helps stop heat and spills from reaching internal components by restoring the factory sealing and fit
• Restores a flush, stable surface for grates, burner caps, and control knobs

• Main top assembly (1)

• Disconnect power to the range before starting; if gas-equipped, turn off the gas supply
• Remove grates, burners, and any trim pieces before lifting the old top; keep fasteners for reuse unless replacement parts are required
• Lift and align the new top carefully to avoid chipping or scratching; verify burners and controls seat correctly before reassembly

A replacement hinge bracket that secures and aligns the refrigerator door, restoring proper pivot and fit for smooth opening and closing. Install this bracket to correct sagging or misaligned doors and improve door seal performance. What it does

• Secures the door hinge to the cabinet and supports door weight — use when the door droops or hangs unevenly.
• Maintains pivot alignment so the door opens and closes smoothly without binding.
• Helps keep the door gasket aligned for a tighter seal; can reduce uneven gaps and cold-air loss.
• Replaces bent, cracked, or worn hinge-mounting points that cause noise or instability.

• One hinge bracket.

• Disconnect power to the appliance before starting work and remove or support the door to prevent injury.
• Support the door while removing and installing the bracket; a second person may be needed for large doors.
• Reuse existing hinge hardware if undamaged; replace fasteners if stripped or missing.
• After installation, check door alignment and adjust hinge position as needed for a proper seal.

Size: 10-24 x 1.375 inch.

This genuine oven bake element heats the oven cavity for baking and roasting, restoring proper cooking temperatures and consistent results. Replaces a damaged or non-heating bake element to bring your oven back to service. What it does:

• Heats the oven cavity so food reaches and holds set temperatures
• Restores even baking and roasting when the oven fails to heat
• Replaces elements that show visible damage, burn-through, or no glow
• Works with electric ovens that use a separate bake heating element

• Disconnect power to the appliance at the breaker before starting work
• Handle the element carefully to avoid bending or damaging terminals
• Remove oven racks and access the element from inside the oven
• Verify proper fit and secure mounting; tighten terminal fasteners firmly and restore power to test

This thermo disc is a small temperature-sensing switch that helps monitor and control appliance temperatures to protect components and support proper operation. It fits into the appliance's temperature circuit and responds at a designed trip point. What it does

• Senses temperature and opens or closes an electrical circuit at its rated trip point
• Helps prevent overheating by interrupting power when temperatures exceed the design threshold
• Supports proper temperature control for timed cycles or safety systems
• Commonly used in temperature-regulation and safety applications inside appliances

• One thermo disc

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Replace only with the exact part number for proper function and safety
• Handle the disc carefully; avoid bending or damaging the sensing element or terminals

This oven rack is a replacement wire shelf that supports cookware and bakeware inside the oven cavity, restoring proper spacing and airflow for even cooking and broiling. Ideal when the original rack is bent, rusted, or missing. What it does:

• Provides a stable surface for pans, baking sheets and cookware
• Restores correct oven spacing for even heat circulation
• Replaces bent, warped or corroded racks that catch or bind
• Enables use of multiple rack positions for different cooking needs

• Allow the oven to cool completely and disconnect power before installing
• Position rack with the rolled edges toward the oven walls and slide into desired rack guides
• Use gloves to avoid sharp edges and protect finishes
• Clean gently with non-abrasive cleaners; do not use oven self-clean while rack is in place unless rack is rated for self-clean cycles

This wiring harness connects electrical components so your appliance receives reliable power and signal communication. Replacing a damaged harness restores proper electrical flow and helps prevent intermittent operation or control errors. What it does:

• Routes power and control signals between components like switches, sensors, and control boards
• Replaces brittle, frayed, or corroded wires that can cause intermittent operation
• Helps resolve symptoms such as unresponsive controls, no power to a circuit, or erratic component behavior
• Maintains secure plug-to-socket connections to reduce arcing and poor contact

• Disconnect power to the appliance before starting any repair to avoid shock or short circuits
• Compare the harness connectors to the original to ensure correct fit and routing before installation
• Secure harness routing away from sharp edges and heat sources; use existing clamps or ties

The Screw is an OEM part for Frigidaire ranges and ovens. This part is designed to securely fasten various parts of the appliance, ensuring stability and durability. 

Over time, screws can become loose due to the expansion and contraction of materials with temperature changes. Regular use and the occasional necessary removal for repairs or cleaning can also wear down the threads, making them less effective.  

Symptoms of a bad Screw (Chrome) include:

• Loose or wobbly components that should be securely fastened.
• Difficulty in securing parts due to stripped or damaged screw threads.
• Visible corrosion or deterioration of the screw.

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Size: 8-18 x 0.5 inch. Color: Chrome.

The Screw is an OEM part for Frigidaire ranges and ovens. This part is designed to securely fasten various parts of the appliance, ensuring stability and durability. 

Over time, screws can become loose due to the expansion and contraction of materials with temperature changes. Regular use and the occasional necessary removal for repairs or cleaning can also wear down the threads, making them less effective.  

Symptoms of a bad Screw (Chrome) include:

• Loose or wobbly components that should be securely fastened.
• Difficulty in securing parts due to stripped or damaged screw threads.
• Visible corrosion or deterioration of the screw.

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Size: 8-18 x 0.5 inch. Color: Chrome.