Parts for Frigidaire PGLEF385ES3: 07 - Top / Drawer Parts

This is a 100 watt, 120 volt surface warming element. Includes limiter.

6 inch, 1200 watt single radiant surface element.

This replacement surface element restores proper heating on a 6-inch burner, so you can cook evenly and bring pans up to temperature as expected.

• Heats cookware on a 6-inch cooktop position
• Common failure signs: burner won't heat, heats intermittently, or trips off under load
• Restores consistent, controllable surface heat
• Direct fit for the designated element location

• Disconnect power before servicing
• Allow the cooktop to cool fully before handling
• Lift/remove the old element carefully to avoid damaging terminals or receptacle
• Inspect and replace the element receptacle as needed

This main top is the replacement cooktop surface that covers your range's heating area and supports burners and grates. Restores the look and sealing surface of the cooktop after damage or wear. What it does:

• Provides the primary flat surface for burners, grates and controls to mount to
• Replaces warped, dented, rusted or otherwise damaged cooktop tops that allow soot or debris buildup
• Helps maintain correct spacing and alignment for burner components and trims
• Prevents heat or spills from reaching internal cabinet areas when intact

• One main top

• Disconnect power and gas supply before starting any repair
• Some models require removing grates, burners, control panel or oven top screws to lift out the old top
• Handle carefully to avoid scratches or bending; alignment tabs must seat correctly for a proper fit

Specs: 8 - 18 x 0.500

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts

Replacement machine screw used to secure appliance panels and internal components, restoring a stable fit and reducing rattling. Matches a 10-32 thread with a 17/32-inch length for original fastener locations. What it does:

• Fastens panels, trim pieces, and internal brackets; a missing or damaged screw can cause loose panels or rattling noises.
• Secures knobs, control housings and small assemblies to prevent wobble or misalignment.
• Restores proper fit for components so doors and access panels sit evenly and function reliably.

• Disconnect power (unplug or shut off circuit) before accessing components.
• Use the correct driver and tighten by hand; avoid overtightening to prevent stripped threads or cracked plastic.
• Keep any original washers or clips and reinstall them with the screw.