Parts for Ge WSM2780WBAA: 06 - Transmission Parts

This cap stud is a small protective cover that helps secure and shield electrical or mechanical studs on appliances, reducing debris buildup and protecting connections. It provides a simple, low-cost way to maintain safe appliance operation. What it does:

• Covers and protects exposed studs or fasteners from dirt and moisture
• Helps prevent accidental contact with terminals or sharp edges
• Keeps mounting hardware in place for a neater appearance
• Can reduce corrosion risk at exposed connection points

• One cap stud

• Inspect the stud and surrounding area for damage before installing
• Push the cap onto the stud until it seats firmly; no special tools typically required
• Disconnect power to the appliance before working near electrical connections
• Replace if damaged, cracked, or loose to ensure continued protection

This tub seal assembly keeps the washer's inner tub sealed around the drive shaft to help prevent water leaks and contain wash water. It replaces a worn or damaged tub seal to restore a watertight fit. What it does

• Seals the gap between the inner tub and the transmission/drive shaft to reduce leaks
• Helps prevent water from entering the transmission area and causing damage
• Commonly replaced when you notice water on the floor or pooling under the washer
• Used when the existing seal is cracked, torn, or excessively worn

• One tub seal assembly

• Disconnect power and shut off water before starting any repair
• Replacement typically requires partial disassembly of the washer (cabinet or front panel removal) and access to the tub/transmission area
• Inspect shaft and surrounding surfaces for wear or damage and clean mounting surfaces before installing the new seal