Trash Compactor Parts

This power cord plate covers and secures the oven/range power cord where it enters the appliance, keeping the connection protected and helping prevent strain on the cord. It restores a finished look and helps keep wiring safely routed. What it does:

• Covers the terminal block area to protect power connections from dirt and accidental contact
• Helps keep the power cord routed and secured to reduce strain on the cord and terminals
• Can prevent air/dust intrusion behind the control cavity that could affect components
• Common replacement when the original plate is cracked, broken, or missing

• Always disconnect power at the breaker or unplug the appliance before starting work
• Typically attaches with two screws; keep screws and any gaskets from the old piece for reuse if undamaged
• Check the cord strain relief/terminal connections while replacing the plate; do not touch live terminals
• If wiring or the cord itself is damaged, replace or repair those parts per manufacturer instructions

Size: 6-20 x 1.0 inch.

Bottle with brush. Acyrlic touch-up paint. Color: Hunter green. Size: 0.6 fl.oz.

White switch plate for trash compactors. Covers and protects the control switch area. Replace if cracked, discolored, broken, or missing.

White front panel for trash compactors. Replaces cracked, damaged, or discolored panels. Installs on the front exterior of the compactor cabinet.

Color: Black.

Biscuit-colored front panel for trash compactor container. Replace this decorative trim piece if cracked, discolored, or damaged to restore appearance.

Button plug for trash compactor control panel. Replaces missing, cracked, or worn plugs that create gaps in the control surface. Restores appearance.

This stainless container panel replaces a damaged or worn front for the refrigerator's storage container, restoring the compartment's appearance and helping the drawer close cleanly. It matches OEM fit and finish for a factory look. What it does:

• Replaces a scratched, dented, or corroded container/front panel
• Restores the drawer/container appearance and front edge alignment
• Helps the drawer seal and slide as intended when the front is intact
• Fits into the existing container assembly and uses factory mounting points

• One stainless container panel

• Requires basic disassembly of the container/drawer; keep fasteners and clips organized
• Inspect mating edges and clips for damage; replace any broken hardware separately
• Disconnect power only if working near electrical components; follow appliance-specific service manual