Parts for Ge ASP08AAS1: 01 - Section1 Parts

A 25 microfarad (25µF) run capacitor rated 330 VAC that helps motors and compressors start and run smoothly by storing and releasing electrical charge. Replaces a failed capacitor to restore normal motor operation and reduce noise or intermittent starts. What it does:

• Provides the phase shift and stored energy needed for motor/compressor startup and stable running
• Helps reduce humming, slow starts, or motors that won't maintain speed
• Supports consistent electrical performance under normal load conditions
• Used in motor circuits where a 25µF, 330VAC run capacitor is specified

• Disconnect power to the appliance at the breaker before servicing.
• Discharge the capacitor before handling; residual voltage can cause a shock.
• Observe polarity/terminal labeling and secure connections; replace with exact capacitance and voltage rating.

This part has been discontinued and is no longer available.

This damper door controls air flow between compartments to help maintain proper temperatures and even cooling. It replaces a broken or stuck door so the refrigerator can regulate cold air circulation more reliably. What it does:

• Opens and closes to direct airflow between freezer and fresh-food compartments
• Restores balanced cooling when a worn or cracked door prevents proper air transfer
• Can stop drafty spots or temperature fluctuations caused by a stuck or broken damper
• Works with the damper housing and actuator to modulate vent position

• One damper door part

• Disconnect power to the appliance before starting any repair
• Remove any necessary interior panels or vent housings to access the damper assembly
• Handle the door and surrounding plastic gently to avoid cracking; verify proper orientation before reassembly
• If the actuator or damper housing is damaged, inspect and replace those components as needed

This heat sink helps remove excess heat from the appliance control area to protect electronic components and improve long-term reliability. It's a direct-replacement part designed to match the original form and mounting. What it does:

• Conducts and disperses heat away from the control board and sensitive electronics
• Helps prevent overheating symptoms such as intermittent control failures or component stress
• Supports stable operation during high-heat cycles or heavy use
• Fits the original mounting points to maintain proper airflow and clearance

• One heat sink

• Disconnect power before starting any repair to avoid electrical shock
• Handle carefully — edges may be sharp and electronic components can be static-sensitive
• Verify correct placement and secure all fasteners; follow the appliance service manual for routing and orientation

This retainer strap secures the condenser cover to the appliance chassis to keep the condenser assembly protected and prevent vibration-related noise. It's a simple replacement to restore proper cover fit and stability. What it does:

• Holds the condenser cover/guard firmly in place to prevent rubbing and rattling
• Keeps the condenser area protected from debris and incidental contact
• Helps maintain correct airflow path by keeping the cover properly seated
• Addresses symptoms like loose or vibrating cover and associated noise

• One strap condenser cover retainer (single strap)

• Disconnect power to the appliance before beginning any service
• Access may require removing the toe grille or lower access panel; keep fasteners for reassembly
• Use basic hand tools; avoid overtightening to prevent damage
• If you encounter damaged mounting tabs or clips, inspect those components separately and replace as needed