Parts for Ge FUM14SVERWW: 03 - Unit Parts

Drier filter for freezer refrigeration system. Installs in refrigerant line to remove moisture. Replace if clogged, damaged, or during compressor repairs.

Fix a freezer that won't cool or runs constantly with a new compressor relay and overload. Common fix for warm temps and cycling issues in upright freezers.

Fix a freezer compressor that won't start or struggles to run. This start capacitor provides the electrical boost needed for reliable motor operation.

This controller clip secures a control board or wiring harness inside the appliance, preventing movement and reducing the chance of loose connections or interference. A simple replacement that restores proper board mounting and stability. What it does

• Holds the control board or harness in place to prevent vibration and movement
• Helps maintain reliable electrical connections by reducing strain on wiring
• Reduces rattling or contact noise caused by loose internal components
• Can prevent intermittent operation caused by a poorly secured board or wires

• One controller clip

• Disconnect power to the appliance before starting any repair.
• Access the control area per your model's service instructions; remove panels carefully to reach the clip.
• Handle the control board and connectors by their edges; avoid touching circuit traces or components.

A replacement mounting wire clip that secures refrigerator or appliance wiring harnesses to the cabinet or chassis to prevent rubbing and strain. Helps restore correct wire routing and reduces the risk of chafing or intermittent connections. What it does:

• Clips wiring harnesses or individual wires to the frame or panels to keep wires held securely in place
• Prevents wires from contacting sharp edges, heating elements, or moving parts
• Reduces vibration-related noise and intermittent electrical connections
• Useful when original clips are broken, cracked, or missing

• Disconnect power before accessing wiring or removing panels
• Remove any required access panels or trim to reach the clip location; keep fasteners for reassembly
• Slide the harness into the clip or snap the clip into the mounting hole until fully seated; avoid forcing to prevent breakage
• Inspect adjacent wire insulation and replace or re-route damaged wiring before restoring power