Parts for Roper X07502V0: 02 - Unit Parts

This part has been discontinued by the manufacturer and is no longer available.

This is a genuine lock nut replacement. This is a general piece of hardware that is often used on several types of lawn and garden equipment, including in engines, housing, and other areas. The exact application of this part will vary based on the unit. The lock nut is used to create a more secure seal than a standard nut. When properly secured, the lock nut tightens to a bolt and uses an extra locking washer with teeth to ensure a snug fit.If lock washers do get damaged or lost, they need to be replaced immediately with a genuine OEM replacement. This model is compatible with all types of machines and units since it is a generic part. The washer is sold as an individual part and manufactured by Whirlpool. Lock nuts will need to be installed using a socket wrench or adjustable wrench. Pliers, a screwdriver, or another socket wrench will be needed to hold the bolt while the lock nut is being secured in place. Be sure to thread the lock nut carefully to ensure a strong seal and avoid stripping the bolt or the nut.

This rear oven cavity bracket secures and supports the oven's back panel and internal cavity, restoring proper alignment and stability for safe operation. Designed to replace a damaged, bent, or missing rear support bracket. What it does:

• Secures the oven rear panel and internal cavity to the chassis to prevent vibration and misalignment
• Restores proper fit between internal components and exterior panels, which helps reduce rattling or scraping noises
• Helps maintain correct spacing for oven components that rely on stable mounting
• Compatible with OEM mounting points and fastener locations on affected oven models

• One rear oven cavity bracket

• Disconnect power (and gas if applicable) before beginning any service
• Inspect surrounding panels and fasteners; replace any damaged screws or clips as needed
• Typically accessed from the back of the oven after removing the rear access panel; refer to your model's service manual for step-by-step guidance

Seal for air conditioners and dehumidifiers. Replace if you notice air leaks, reduced efficiency, or visible wear. Verify compatibility with your model.

Size: 10 x 3/8 inch.

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

This seal strip replaces a worn or damaged door gasket edge to restore a proper seal and help the appliance maintain temperature and operate quietly. It's a direct-fit service part used where a continuous seal is required. What it does:

• Provides a flexible barrier along the door/frame to reduce air leaks and heat/cold loss
• Helps prevent moisture buildup and improves energy efficiency when sealing is restored
• Reduces rattling and vibration caused by a compressed or torn seal edge
• Commonly replaced when the strip is torn, missing, or no longer adheres properly

• One seal strip

• Disconnect power to the appliance before servicing to avoid electrical or burn hazards
• Clean and dry the mounting surface; remove old adhesive or residue for best adhesion
• Align the strip carefully and press firmly; allow any adhesive to cure per manufacturer instructions