Parts for Ge BEH50DCEJSBA: Unit Parts

This dishwasher screw secures internal components and panels within your dishwasher's assembly. It provides proper fastening for pumps, motors, and housing components that keep the unit operating smoothly. Replace this screw if internal parts are loose, vibrating excessively, or if the original screw is damaged or missing.

A flat metal washer used to secure fasteners and distribute load on a washer's assemblies. Replaces worn or missing washers to help maintain proper alignment and reduce metal-on-metal wear. What it does:

• Sits under a nut or bolt head to spread clamping force and protect mating surfaces
• Helps keep fasteners tight and resists loosening from vibration
• Prevents wear and damage to softer components where hardware clamps
• Common symptom: loose or missing washer causing rattling, vibration, or misaligned parts

• One flat metal washer

• Disconnect power and water supply to the appliance before beginning any repair
• Use appropriate hand tools; avoid excessive torque that can deform the washer
• Inspect adjacent fasteners and replace any damaged hardware

This compressor overload protector helps shut off a refrigerator compressor when electrical overload or heat risks occur, protecting the compressor from damage and keeping the cooling system more reliable. What it does:

• Interrupts compressor current during overheating or electrical overload to prevent motor damage.
• Works with the compressor start device/relay to allow proper motor start and run behavior.
• Common symptom linkage: refrigerator not cooling and compressor runs hot, hums, or cycles rapidly.
• Common symptom linkage: compressor will not start but attempts to run or clicks.

• One compressor overload protector.

• Disconnect power to the appliance before inspecting or replacing the overload; follow all safety precautions.
• Handle terminals gently and install in the same orientation; ensure secure electrical connections and proper seating on the compressor.
• If the compressor or start relay shows other damage, inspect the entire start device assembly and wiring; replace any damaged components before restoring power.

This mastic thermal sensor detects oven temperature and helps the control board monitor and regulate heat for safe, consistent cooking. It's a direct-replacement temperature sensing element used where a mastic-mounted sensor is required. What it does:

• Senses appliance temperature and sends a signal to the control module for temperature regulation
• Helps prevent overheating by allowing the control to reduce heat when temperatures exceed set points
• Commonly replaced when an oven runs too hot, won't reach set temperature, or shows temperature-related errors
• Designed for mastic- or adhesive-style mounting to maintain stable thermal contact

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Handle the sensor and lead wires carefully; avoid kinking or stressing the sensing element
• Install in the same orientation and mounting location as the original to ensure proper temperature readings

Spring washer for water heater assembly. Secures components and maintains tension. Replace if washer is cracked, flattened, corroded, or missing.

Replacement washer for water heater assemblies. Installs between pipe connections to create a watertight seal. Order a new washer if cracked or worn.

Wire tie retainer for refrigerators. Secures and organizes internal wiring. Replace if cracked, broken, or missing to keep wires properly bundled.