Parts for Ge PGB960SEJ2SS: Upper Door Parts

This guard insulation is a replacement heat shield that helps protect surrounding components from high oven or range temperatures and maintains safe operation. It's a direct-fit OEM-style panel used where factory insulation is required. What it does:

• Shields nearby components and wiring from heat to prevent premature failure
• Helps contain and direct oven/range heat for consistent performance
• Reduces risk of heat transfer to control panels and adjacent cabinetry
• Replaces torn, burned, or missing insulation that can lead to hot spots or odors

• Disconnect power (unplug or shut off breaker) and allow the appliance to cool fully before starting
• Wear gloves and eye protection—insulation edges can be sharp or irritating
• Remove any damaged insulation and clean mounting area before installing replacement
• Follow OEM instructions for proper placement and secure fasteners; test appliance operation after reassembly

The Handle and End Cap Assembly is an OEM part for GE ovens. This assembly comprises the handle used to open and close the oven door, along with the end caps that secure the handle firmly in place. The handle measures 27.5 inches long

Over time, the handle and end caps can become worn or damaged due to frequent use, exposure to high temperatures, or accidental impact. Such issues can make it challenging to operate the oven door properly and safely.

Symptoms of a bad Handle and End Cap Assembly include:

• Difficulty in opening or closing the oven door
• A loose or wobbly handle
• Visible cracks or damage to the handle or end caps
• The handle detaching from the oven door

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This bracket handle is the replacement mounting bracket that secures a refrigerator/freezer door handle, restoring proper handle alignment and support. It helps stabilize the handle and prevent movement or looseness for reliable daily use. What it does

• Secures the door handle to the appliance cabinet so the handle stays firmly in place
• Restores correct handle alignment and feel after a broken or worn bracket
• Reduces handle wobble, prevent further damage to the handle or door
• Matches OEM fit and form for direct replacement where this bracket is specified

• Basic hand tools required; remove power and empty door pockets before starting
• Follow OEM disassembly steps to avoid damaging trim or the door finish
• Keep hardware and screws from the original assembly; replace only with manufacturer-specified fasteners

This oven door inner insulation cushions the inner door panel and helps maintain proper cooking temperatures while reducing heat transfer to the outer door. Replaces damaged or missing insulation to improve heating consistency and help keep the exterior cooler. What it does

• Fills the cavity behind the oven door's inner panel to limit heat loss and stabilize internal temperatures.
• Helps reduce outer door surface temperature for safer handling during and after use.
• Reduces drafts and uneven cooking caused by compromised or missing insulation.
• Works with the door inner panel and outer door assembly to restore proper sealing and performance.

• One door insulation

• Remove power to the appliance and allow the oven to fully cool before beginning work.
• Handle carefully to avoid tearing the insulation; use caution around sharp sheet metal and door glass.
• Follow manufacturer service manual or OEM instructions for door disassembly and reassembly.

This silicon controlled rectifier (SCR) is an electronic switching component used on appliance control boards to regulate power to heating elements or motors, restoring proper control and operation when the SCR fails. What it does:

• Acts as a power-control switch on control boards to deliver variable current to heaters or motors
• Helps regulate on/off cycles and output under control-board commands
• Failure may cause no heat, intermittent heating, or components not running as expected
• Replacing a faulty SCR can restore consistent power control and appliance function

• Disconnect all power before servicing; risk of electric shock or damage
• Static-sensitive component—use proper ESD precautions when handling
• Replacement typically requires desoldering/soldering on the control board or replacement of the control module