Parts for Ge CTD90FP3M1D1: Upper Doors Parts

This SCR (silicon controlled rectifier) is a replacement power-regulation semiconductor used in select GE appliances to control voltage to heating elements or motors, restoring reliable variable power control and stable operation. What it does

• Regulates and switches power to heating elements or drive motors as part of the appliance's control circuitry.
• Helps maintain consistent heat or motor speed when the control board calls for variable output.
• Can resolve symptoms such as intermittent heating, fluctuating motor speed, or appliances that run only on certain settings.
• Functions as a direct electrical switching component—not a user-serviceable interface.

• One SCR (silicon controlled rectifier) matching OEM part WB01X24096.

• Always disconnect power at the breaker or unplug the appliance before starting any repair.
• Handle the part carefully; observe anti-static precautions and avoid touching leads or terminals.
• Verify the part number on the old component matches WB01X24096 before installation.

This 8-32 machine screw (7/16") is a painted fastener used to secure panels, brackets, and components on compatible appliances. It replaces missing or worn screws to restore proper fit and reduce vibration. What it does:

• Secures panels, control assemblies, brackets, and small hardware
• Restores proper alignment and prevents rattling or loose parts
• Used where an 8-32 thread and 7/16" length are required
• Painted finish matches appliance surfaces and resists corrosion

• One painted 8-32 machine screw, 7/16" length

• Unplug the appliance before servicing to avoid shock or injury
• Use the correct screwdriver or nut driver to avoid stripping the head
• Install by hand to start threads, then tighten snugly—do not overtighten
• Keep track of small parts during disassembly; magnetic trays help prevent loss

A single #8-18, 1/2-inch screw used to secure interior and exterior appliance panels and components. Replaces a worn or missing fastener to restore secure mounting and reduce rattles or loose parts. What it does:

• Fastens panels, trim, brackets, and small components where a #8-18, 1/2" screw is required
• Replaces missing or stripped screws that cause loose panels or vibration noise
• Provides a proper threaded connection for reliable mechanical support
• Matches common OEM panel and trim fastening points

• Unplug the appliance or shut off power before starting any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Tighten securely but avoid over-tightening, which can strip threads or crack panels
• If thread engagement is damaged, replace the mating fastener or insert as needed

This mounting stud secures appliance panels and components in place, restoring proper alignment and stability. It's a simple replacement that helps stop rattling and keeps parts seated correctly for safe operation. What it does:

• Secures panels, brackets, or assemblies to the appliance frame
• Restores proper alignment when a stud is bent, stripped, or missing
• Reduces rattling or vibration caused by loose or damaged fasteners
• Helps maintain safe, stable mounting for controls and internal parts

• Disconnect power to the appliance before servicing.
• Use appropriate hand tools; avoid cross-threading the stud.
• Do not overtighten—tighten until snug to prevent damage.
• If threads are damaged, replace the mating nut or insert as needed.