Parts for Kitchenaid KCDC250X1: 02 - Section Parts

The disposer sleeve is a protective collar that connects the garbage disposer to the sink drain and prevents debris from escaping. Replace it when you notice leaks around the connection point or food particles escaping into the drain area.

The disposer sleeve is a protective collar that connects the garbage disposer to the sink drain and prevents debris from escaping. Replace it when you notice leaks around the connection point or food particles escaping into the drain area.

Thrust washer for garbage disposer motor assembly. Replaces worn, damaged, or missing washers. Essential hardware component for proper installation.

Fix a disposal that won't start with the stopper but works with the wall switch. This auto start switch restores batch feed operation on disposers.

This metal tailpipe directs dryer exhaust from the appliance outlet to the vent system, restoring proper airflow and helping prevent exhaust leakage. It's a direct-fit replacement that reinstates safe venting. What it does

• Channels exhaust air from the dryer outlet to the vent duct to maintain proper airflow
• Helps prevent exhaust leakage behind the dryer that can cause odor or moisture issues
• Stops rattling or misalignment at the dryer outlet caused by a damaged or bent tailpipe
• Supports safe venting performance that can affect drying efficiency

• One tailpipe

• Disconnect power; for gas dryers, shut off the gas supply before starting
• Basic tools (screwdriver/socket) typically required; follow OEM installation instructions
• Ensure the tailpipe is seated and secured to the dryer outlet and vent duct with proper clamps or screws
• After installation, check for leaks, proper alignment, and test dryer operation

Replacement tailpipe flange for disposers. Secures the discharge tailpipe connection. Needed when original flange is cracked, broken, or missing.

Replacement stringer bolt that secures the appliance's stringer or support rail to the cabinet frame, restoring panel alignment and preventing movement. Use when the original bolt is missing, loose, or damaged. What it does:

• Secures the stringer/support rail to the appliance frame so panels and assemblies stay aligned.
• Helps prevent cabinet or panel movement that can cause rattling or vibration during operation.
• Restores proper alignment when a loose or missing bolt causes misaligned panels or binding doors.
• Simple, direct replacement for a corroded, stripped, or lost fastener.

• Disconnect power before working on the appliance and remove any panels.
• Use the correct-size socket or wrench; hand-tighten, then snug—do not overtighten to avoid stripping threads.
• Inspect mating threads and replace the bolt if heads or threads are damaged; for the correct fastener location.

Fix a garbage disposal that won't turn on with this start switch assembly. Compatible with multiple disposer models. Repair restores power control.

Machine screw with 8-18 thread for securing panels, brackets, and components in disposers, ranges, ovens, microwaves, and hoods. Replace missing or stripped screws.

Emergency wrench assembly for garbage disposals. Installs on disposal unit for manual jam clearing. Replace if lost, broken, or missing from installation.

This part has been discontinued by the manufacturer and is no longer available.