Parts for Bosch WTVC853PUC/09: Valve Assembly Parts

Connects water supply to your washer's inlet valve. Replace if hose is cracked, leaking, kinked, or damaged to restore proper water flow during cycles.

This is a branching piece that connects to the water supply line in a dryer, typically used in steam dryer models to split or direct water flow to the appropriate internal components. It ensures proper water distribution for steam generation during drying cycles. Replace this part if you notice water leaks near the connection point or if the steam function is not working correctly.

The Cold Water Inlet Hose is an OEM replacement part for Bosch washing machines. It serves as a flexible supply line that delivers cold water from an external plumbing source directly to the washer. This hose plays an important role in providing a balanced mix of hot and cold water flow into the unit.

Symptoms of a bad cold water inlet hose include:

• Fluctuations in water temperature during cycles  
• Issues with certain temperature settings like warm or cold not operating properly
• Visible cracking, kinking, or leaking along the hose body
• No water flow or pressure at the cold supply 

Causes of a failed cold water inlet hose can be mineral deposits clogging the line, natural wear and tear over time, or physical damage from crushing or abrasive surfaces compromising its integrity.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore washing machine models.

This hose inlet is the water connection hose that routes incoming water to the appliance's inlet valve, restoring proper water feed for cycles. It's a direct-fit replacement designed to match the original part's fit and function. What it does:

• Connects the home water supply to the appliance's inlet valve so water can enter for wash/fill cycles
• Restores proper water flow when the original hose is cracked, split, or leaking
• Helps prevent leaks at the machine entry point when the hose and clamps are properly installed
• Works as the factory-style replacement to maintain correct routing and seal

• One hose inlet

• Turn off power and shut off the water supply before attempting replacement
• Drain residual water from the supply line and appliance to minimize spills
• Inspect and replace any worn clamps or seals; hand-tighten then secure clamps per manufacturer guidance

This spray head nozzle directs water from the upper spray arm to improve spray coverage and rinsing performance in compatible dishwashers. Replace a cracked or clogged nozzle to restore targeted spray patterns. What it does:

• Directs pressurized water through the upper spray arm for effective cleaning and rinsing
• Replaces a worn, cracked, or clogged nozzle that can cause poor cleaning or uneven spray
• Helps prevent spray arm wobble or misdirection when securely seated
• Reduces spotting and residue caused by blocked or damaged spray openings

• One spray head nozzle for the upper spray arm

• Disconnect power and water to the dishwasher before beginning any service
• Remove the upper rack and spray arm to access the nozzle per your model's service instructions
• Press or snap the nozzle into the spray arm opening until fully seated; avoid overtightening
• After installation, run a short rinse cycle to confirm correct spray pattern and that there are no leaks