Parts for Bosch DHG6023UC/01: Vent System Parts

This stud is a small mounting fastener used to secure appliance panels and components, restoring proper fit and preventing unwanted movement. It's a direct-fit replacement that helps eliminate vibration and rattling caused by loose hardware. What it does

• Provides a secure anchor point for panels, trim, or internal components
• Restores correct alignment to prevent gaps and rubbing noises
• Helps stop vibration-related rattling or movement during operation
• Compatible where the OEM stud PN 00641729 is specified

• One mounting stud

• Disconnect power and/or gas supply before beginning any repair
• Use appropriate hand tools; avoid overtightening to prevent thread or component damage
• Replace any damaged mating hardware as needed for a safe, secure fit
• Test the appliance after reassembly to ensure the part corrected the symptom

This is a fan motor that is installed inside several range hoods. It is located inside the hood and helps ensure the fan operates correctly. As a part of the fan, this motor helps filter smoke and other contaminants in the kitchen air to the outside of the home. It removes fumes, greases, steam, and heat from the air. If the fan is no longer operating on a range hood, this could be the result of a damaged fan motor. If that's the case, the component will need to be replaced.First, make sure the range hood is unplugged or the circuit breaker has been turned off. Remove the bottom panel and filters from the appliance. Take off the side panels and pull the range hood down from the cabinet. The fan blade will need to be removed to access the fan motor. Take out the old motor and install the replacement part before reassembling the range hood for use.The fan motor is sold as an individual item. It is a genuine OEM replacement component that is sourced directly from the manufacturer. This part is made for use with range hoods made by Bosch and Thermador.

A replacement motor capacitor that helps the appliance motor start and run smoothly, restoring reliable operation when the original capacitor fails. Fits specified Bosch appliances that use this OEM-designed capacitor module. What it does:

• Provides the phase shift and stored energy a motor needs to start and maintain proper speed
• Commonly replaced when the motor hums, won't start, runs weakly, or cycles irregularly
• Prevents excessive motor strain that can lead to overheating or early motor failure
• Matches the original form and electrical function for direct replacement where specified

• Always disconnect power to the appliance before servicing
• Capacitors can hold charge—discharge safely
• Handle and mount the capacitor as the original part was installed; avoid crushing or puncturing the can

The one-way flap is an OEM part for Bosch vent hoods. Located inside the hood cavity, it allows air to exit while preventing grease and smoke from traveling backward during ventilation.

Causes of a bad one-way flap can include prolonged exposure to cooking residue and vapors, as well as wear from continuous use. Failure to clean internal hood surfaces also contributes to eventual component deterioration. 

Symptoms of a bad vent hood one-way flap include:

• Reduced or inefficient ventilation out of the hood 
• Grease and smoke escaping into the kitchen rather than outside
• Decreased airflow causing higher ventilation motor speeds
• Grease accumulating on internal hood surfaces

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.