Viking PM100069 Turntable Motor (Microwave Oven) OEM Part

Down loaded the manual from http://www.manualslib.com/download/555901/Viking-Vmos200.html PG 33 1. Disconnect the power supply cord. 2. Remove turntable and turntable support from oven cavity. 3. Lay the oven on it's backside. Remove the turntable motor cover by snipping off the material in four corners. 4. Where the corners have been snipped off bend corner areas flat. No sharp edges must be evident after removal of the turntable motor cover. 5. Disconnect wire leads from turntable motor. 6. Remove one (1) screw holding turntable motor to oven cavity. 7. Now the turntable motor is free. 8. After replacement use one (1) new 3/8" #8 sheet metal screw to attach the turntable motor cover. Not provided with replacement motor Took 15 min to fix

Removed microwave from wall: - remove surround bracket with 4 screws and then microwave just lifts out Loosened bottom of Microwave, pried open and replaced motor: - removed 10 Phillips screws holding bottom of microwave -Removed 2 Phillips screws on each side of microwave holding cover -Needed to remove 2 locked torx screws on back that hold cover, but did not have tool. -Since cover would not come off (did not have tool), I pried the bottom open from the front edge of the microwave and had reasonably easy access to the one screw holding the motor -Replaced motor and re-assembled. Worked great, though the side cover is slightly bent due to my inability to remove the locked torx screws. It is in the wall, so nobody will every know.