Parts for Ge CTW900P3N1D1: Warming Drawer Parts

This replacement power cord supplies mains electricity to an electric range or oven, restoring reliable power and replacing worn or damaged cords for safe operation. What it does:

• Carries mains voltage from the wall outlet to the appliance's terminal block
• Replaces frayed, burned, or damaged cords that can cause intermittent power or arcing
• Stops power failures caused by a faulty or broken cord assembly
• Helps eliminate overheating or sparking at the plug or connection point

• Always disconnect power at the breaker or fuse box before servicing the appliance
• Secure under the strain relief/cover
• Follow local electrical codes and the appliance wiring diagram when attaching the cord

This handle plate is the exterior trim piece that attaches under a refrigerator/freezer or appliance door handle to restore appearance and provide a finished look. Replaces a cracked, chipped or loose handle trim to improve door aesthetics and grip. What it does:

• Covers and secures the area beneath or around the door handle, protecting the cabinet surface
• Restores the finished appearance of the door after damage or wear
• Helps stabilize the handle area when fastened properly
• Commonly replaced when trim is cracked, broken, scratched, or missing

• One handle plate

• Basic hand tools typically required; do not overtighten fasteners
• Before starting, disconnect power to appliances with electrical components
• Handle trim may snap or screw into place—remove broken pieces carefully to avoid scratching surrounding finish

This nut holder is a small mounting retainer that secures a matching nut in place to keep panels, assemblies or components fixed and properly aligned. It replaces a worn or broken retainer to restore secure fastening and reliable fit. What it does

• Holds a nut in a fixed position so fasteners stay secure during normal use and vibration.
• Keeps panels and trim aligned by preventing nuts from rotating or backing out.
• Helps resolve loose or rattling panels, trim pieces or small assemblies.
• Works where space or access makes using a wrench on the nut difficult.

• Disconnect power to the appliance before starting work and follow all safety guidelines.
• Access may require removing panels or trim; keep track of screws and hardware.
• Slide or clip the retainer into the mounting slot, seat the nut, then install the mating fastener.
• Do not overtighten the fastener — snug is sufficient to avoid damaging the retainer.

This mounting stud secures appliance panels and components in place, restoring proper alignment and stability. It's a simple replacement that helps stop rattling and keeps parts seated correctly for safe operation. What it does:

• Secures panels, brackets, or assemblies to the appliance frame
• Restores proper alignment when a stud is bent, stripped, or missing
• Reduces rattling or vibration caused by loose or damaged fasteners
• Helps maintain safe, stable mounting for controls and internal parts

• Disconnect power to the appliance before servicing.
• Use appropriate hand tools; avoid cross-threading the stud.
• Do not overtighten—tighten until snug to prevent damage.
• If threads are damaged, replace the mating nut or insert as needed.

This rubber grommet seals the cabinet opening where a water valve or hose passes through, helping prevent leaks and reducing vibration. It's a simple replacement that restores a tight, water-resistant seal around the valve area. What it does

• Provides a cushion and seal around a water valve or hose where it passes through the cabinet wall
• Helps stop drips or minor leaks that travel along the cabinet opening
• Reduces vibration and rattling from the valve or connected lines
• Commonly replaced when the original grommet is cracked, brittle, or missing

• One grommet

• Disconnect power and shut off the water supply before starting any work
• Remove the old grommet and clean the mounting area; push the new grommet into the valve hole until fully seated
• Inspect valve hose alignment and test for leaks after restoring power and water