Parts for Ge CW9000SJ1SS: Warming Drawer Parts

This replacement power cord supplies mains electricity to an electric range or oven, restoring reliable power and replacing worn or damaged cords for safe operation. What it does:

• Carries mains voltage from the wall outlet to the appliance's terminal block
• Replaces frayed, burned, or damaged cords that can cause intermittent power or arcing
• Stops power failures caused by a faulty or broken cord assembly
• Helps eliminate overheating or sparking at the plug or connection point

• Always disconnect power at the breaker or fuse box before servicing the appliance
• Secure under the strain relief/cover
• Follow local electrical codes and the appliance wiring diagram when attaching the cord

This SEMS screw secures panels and components inside your appliance for reliable fastening and stable operation. It's a direct-fit fastener used where a captive washer and threaded screw are required. What it does

• Fastens panels, brackets, control assemblies and other internal components
• Helps stop rattling, loose parts, and misalignment caused by missing or worn screws
• Captive washer design keeps the washer in place during installation
• Common replacement when original fasteners are corroded, stripped, or missing

• Use proper screwdriver or driver bit to avoid stripping the head
• Tighten until snug; avoid over-torquing which can strip threads or damage parts
• Disconnect power before servicing electrical components
• Replace all similar fasteners for even fit and alignment

This rubber grommet seals the cabinet opening where a water valve or hose passes through, helping prevent leaks and reducing vibration. It's a simple replacement that restores a tight, water-resistant seal around the valve area. What it does

• Provides a cushion and seal around a water valve or hose where it passes through the cabinet wall
• Helps stop drips or minor leaks that travel along the cabinet opening
• Reduces vibration and rattling from the valve or connected lines
• Commonly replaced when the original grommet is cracked, brittle, or missing

• One grommet

• Disconnect power and shut off the water supply before starting any work
• Remove the old grommet and clean the mounting area; push the new grommet into the valve hole until fully seated
• Inspect valve hose alignment and test for leaks after restoring power and water

Replacement badge designed to restore the appliance's exterior appearance and factory look. This decorative emblem replaces a faded, scratched, or missing badge so the control panel or door presents a clean, branded finish. What it does:

• Replaces a worn, cracked, faded, or missing badge to restore original appearance
• Sits on the appliance front where the original emblem was located for accurate visual match
• Helps maintain a factory-fresh look after cosmetic damage or panel repair
• Sold as the individual decorative emblem; intended as a direct-fit cosmetic replacement

• Clean and fully dry the mounting area before installing to ensure proper adhesion and fit
• Align carefully with the original location; press firmly and evenly to secure the badge