Parts for Ge PTW9000SN1SS: Warming Drawer Parts

This replacement power cord supplies mains electricity to an electric range or oven, restoring reliable power and replacing worn or damaged cords for safe operation. What it does:

• Carries mains voltage from the wall outlet to the appliance's terminal block
• Replaces frayed, burned, or damaged cords that can cause intermittent power or arcing
• Stops power failures caused by a faulty or broken cord assembly
• Helps eliminate overheating or sparking at the plug or connection point

• Always disconnect power at the breaker or fuse box before servicing the appliance
• Secure under the strain relief/cover
• Follow local electrical codes and the appliance wiring diagram when attaching the cord

This stainless steel handle and end cap replace a damaged or worn door handle to restore grip and appearance. Designed for direct fit, it gives the door a clean, finished look and a solid feel when opening and closing. What it does:

• Replaces a bent, cracked or dented door handle to restore safe, secure opening and closing
• Replaces a missing or broken end cap that exposes fasteners or leaves the handle loose
• Restores the door's finished appearance when the original handle shows wear or damage
• Matches stainless-steel finishes for a cohesive look

• High-level replacement; basic hand tools typically required. Do not overtighten fasteners.
• Support the door during removal/installation to avoid damage or injury.
• Disconnect power only if instructed by the appliance manual for your specific model.

This rubber grommet seals the cabinet opening where a water valve or hose passes through, helping prevent leaks and reducing vibration. It's a simple replacement that restores a tight, water-resistant seal around the valve area. What it does

• Provides a cushion and seal around a water valve or hose where it passes through the cabinet wall
• Helps stop drips or minor leaks that travel along the cabinet opening
• Reduces vibration and rattling from the valve or connected lines
• Commonly replaced when the original grommet is cracked, brittle, or missing

• One grommet

• Disconnect power and shut off the water supply before starting any work
• Remove the old grommet and clean the mounting area; push the new grommet into the valve hole until fully seated
• Inspect valve hose alignment and test for leaks after restoring power and water

Replacement badge designed to restore the appliance's exterior appearance and factory look. This decorative emblem replaces a faded, scratched, or missing badge so the control panel or door presents a clean, branded finish. What it does:

• Replaces a worn, cracked, faded, or missing badge to restore original appearance
• Sits on the appliance front where the original emblem was located for accurate visual match
• Helps maintain a factory-fresh look after cosmetic damage or panel repair
• Sold as the individual decorative emblem; intended as a direct-fit cosmetic replacement

• Clean and fully dry the mounting area before installing to ensure proper adhesion and fit
• Align carefully with the original location; press firmly and evenly to secure the badge