Parts for MJ9500: Washer / Dryer Combo Parts

This manifold blower assembly directs air from the dryer blower housing into the heating and venting path so the appliance dries efficiently. It replaces a cracked or damaged blower manifold to restore proper airflow routing. What it does:

• Channels blower airflow from the blower housing to the heater box and vent
• Prevents air leaks that reduce drying performance or cause inconsistent temperatures
• Helps maintain proper airflow for reliable heating and venting
• Replaces manifolds that are cracked, warped, or broken

• One manifold blower assembly

• Disconnect power before beginning; for gas dryers also shut off the gas supply
• Handle carefully to avoid cracking the plastic mounting tabs; inspect mating surfaces and seals
• After installation, check for proper airflow and secure fit before returning the appliance to service

This thermostat regulates oven/heater temperature to help maintain consistent cooking or drying performance. It replaces a failed temperature control device so the appliance can heat and cycle correctly. What it does:

• Senses and controls heater temperature to open/close the circuit at set points
• Helps prevent overheating by interrupting power when temperature exceeds the switch setting
• Common symptoms it can address: appliance not reaching or maintaining temperature, heater running continuously, or heater not turning on
• Electrical switching component only—does not include knobs, wiring harnesses, or display assemblies

• One thermostat (heater temperature control switch) as shown

• Disconnect power to the appliance before servicing to avoid shock or injury
• Handle terminals carefully; loose connections can cause intermittent operation

This door strike latch secures the refrigerator/freezer door by engaging the striker so the door stays closed and seals properly. It helps restore reliable door closure and can stop doors from popping open unexpectedly. What it does:

• Catches and holds the door closed so the gasket can seal
• Ensures the door engages the striker for consistent closing
• Can stop audible rattling or intermittent opening when the latch is worn
• Helps maintain proper door alignment for better temperature performance

• One door strike latch

• Disconnect power to the appliance before servicing to avoid electrical shock
• Remove any door trim or screws that block access to the latch assembly
• Replace the latch, align it with the striker, then tighten fasteners securely
• Test the door operation several times to ensure proper engagement and sealing