Parts for QNW118PSMWW: Washer Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This is the cold water inlet fill hose that connects the household water supply to the washing machine's cold water inlet valve. It delivers cold water into the machine during wash and rinse cycles. Replace this hose if you notice leaking at the connections, visible cracks or bulging in the hose, or if the washer is not filling properly with cold water.

This is a replacement cabinet handle that restores a secure grip and easy access to your appliance door or compartment. It fits where the original handle is cracked, loose, or missing and matches OEM mounting locations. What it does

• Provides a sturdy, ergonomic grip for opening and closing the cabinet or appliance door
• Replaces cracked, broken, or worn handles that make doors hard to open
• Restores original fit and alignment when the existing handle is loose or damaged
• Matches factory mounting points to simplify replacement

• Use basic hand tools; avoid overtightening fasteners which can crack plastic parts
• If replacing a handle on an electrical appliance door, disconnect power before working near controls
• Keep removed fasteners and any decorative trim to reuse if applicable

Secures the power cord strain relief to your dryer chassis. Replaces lost or damaged mounting screws to restore secure cord attachment and reduce stress.

Cabinet-leveling caster wheel that supports the washer and allows rolling for cleaning or service. Replace if worn, broken, or missing to restore mobility.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This clamp secures the internal drain hose to the pump inlet, helping stop leaks and keeping the drain connection tight. It's a direct-fit replacement used on compatible GE washers/dishwashers. What it does:

• Holds the internal drain hose firmly to the pump inlet to prevent water leaks
• Helps maintain proper drain flow by keeping the hose seated and sealed
• Can reduce vibration-related loosening of the hose connection
• Addresses common symptoms like water pooling under the appliance, leaks from the pump area, or intermittent draining issues

• One internal drain hose clamp for the pump inlet

• Disconnect power and water supply before attempting any service
• Access may require removing the appliance front or rear panel
• Verify hose position and seating before tightening the clamp; avoid over-tightening which can damage hose

Fix water leaks or pooling inside your washer with this drain hose clamp. Secures the internal drain hose to prevent water buildup. Simple DIY repair.

This drain hose assembly routes defrost and condensation water from the evaporator to the refrigerator drain pan, preventing pooled water and ice buildup. Replaces a damaged or clogged hose to restore proper drainage and reduce leaks. What it does:

• Channels defrost and condensate water away from the evaporator area to the drain pan
• Restores normal drainage when the original hose is cracked, split, clogged, or collapsed
• Helps stop water pooling inside the fresh food or freezer compartments
• Reduces risk of ice build-up or odor caused by trapped water

• One drain hose assembly as shown

• Disconnect power to the appliance before starting any repair
• Remove any shelving or panels needed to access the evaporator and drain routing
• Ensure hose is seated securely at both ends and routed without kinks or sharp bends
• After installation, run a short manual defrost or pour water down the drain to verify proper flow

Captures lint and fabric fibers in your washer's drain system. Replace when clogged or damaged to maintain proper drainage and prevent blockages.

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.