Parts for Whirlpool WET4124HW0: Washer Top And Control Parts

The Lid Assembly is an OEM part for Whirlpool washers. It provides a protective barrier maintaining internal temperatures while allowing easy access.

Causes for replacement include cracked or depressed surfaces from years of use. Deterioration of seals from chemical exposure can also compromise intended leak resistance.

Symptoms relate to:

• Inability to securely lock lid in fully covered position
• Drafts sensed around perimeter when washing
• Warping reducing flush fit across washer enclosure
• Loosening from hinge pin attachments disrupting function

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

Replacement access panel cover for washer dryer combos. Shields internal components and wiring. Installs to restore proper fit when original is cracked or missing.

Replacement mounting screw for washer dryer combo units. Secures internal components and panels. Needed when original screw is stripped, missing, or lost.

Replacement top panel for washer dryer combo units. Covers the upper cabinet section and supports the control area. Needed when original is dented, rusted, scratched, or damaged.

This switch detects when the washer drum load becomes unbalanced during the spin cycle and signals the control board to pause or redistribute the load. It helps protect the machine from excessive vibration and potential damage. Replace this switch if the washer fails to spin, stops mid-cycle frequently, or does not detect obviously unbalanced loads.

This replacement screw is a direct-fit fastener designed to secure appliance panels and components, restoring proper fit and reducing vibration or rattling caused by missing or loose hardware. What it does:

• Fastens panels, trim, brackets, or components to restore proper alignment
• Stops rattling or vibration caused by loose or missing screws
• Maintains structural fit where original hardware has been lost or damaged
• Matches OEM thread and head type for a secure, low-profile fit

• Disconnect power and water to the appliance before starting work
• Use the correct screwdriver or bit to avoid stripping the head
• Do not overtighten; tighten until snug to prevent damage to threads or plastic parts
• If replacing multiple fasteners, use matching OEM screws to ensure even fit

Fix a washer that overfills, underfills, or won't drain with a new water level pressure switch. Monitors water pressure to control fill cycles.

Replace your washer dryer combo's worn, cracked, or leaking hose. This essential water line ensures proper flow between components during wash cycles.

Fix a washer that won't fill or continuously fills with this water inlet valve. Controls hot and cold water flow into the tub. Simple DIY repair.

Fix a washer dryer combo that won't start cycles or fill with water. This control board manages all electronic functions and sensor inputs.

If your washer lid won't lock or the cycle won't start, this lid latch secures the lid during operation. Moderate difficulty repair with panel removal.

Fixes intermittent operation and control issues caused by damaged wiring. This harness assembly restores proper power and signal connections between components.