Parts for Ge PF40S10FPY01: Water Heater Assembly Parts

Restore your appliance's factory look with this badge assembly. It replaces a missing, cracked, or faded logo on the refrigerator exterior, delivering a clean, professional appearance without affecting performance or operation.

• Decorative nameplate/logo for the refrigerator exterior
• Replaces cracked, faded, loose, or missing badge
• Restores a clean, factory appearance
• Cosmetic component; does not impact cooling or function

• Disconnect power before servicing the appliance
• Protect the finish; use a plastic trim tool to remove the old emblem if needed
• Clean and dry the mounting area; align with locating marks/holes and secure per your model diagram

This is a 10-32 x 1/2 screw with a hex washer-style head used to fasten appliance panels and components securely. It replaces missing or damaged fasteners to restore proper fit and reduce vibration. What it does:

• Secures panels, brackets, and trim to the appliance frame
• Provides a low-profile, washer-style bearing surface for even clamping
• Helps stop rattling and movement caused by loose or missing screws
• Designed for use where a 10-32 thread and 1/2" length are specified

• Disconnect power and water before servicing the appliance
• Use the correct 10-32 driver or socket to avoid stripping the head
• Tighten until snug; do not over-torque to prevent thread or part damage
• Replace with the exact screw size and type for safe, proper fit

This is a replacement 10-32 x 3/8" pan-head screw for fasteners used in appliances. It restores secure fastening for panels, brackets, and trim where the original screw has stripped or gone missing. What it does:

• Secures panels, brackets, or components where a 10-32 thread is required
• Restores proper fit when original screw is worn, damaged, or missing
• Helps eliminate rattles or movement from loose fasteners
• Small fastening solution for repairs on appliance interiors and exterior trim

• One 10-32 x 3/8" pan-head screw

• Use the correct size screwdriver or nut driver to avoid stripping the head
• Do not overtighten; torque gently until snug to prevent thread or component damage
• Replace like-for-like with the same thread size and length for proper fit
• Wear safety glasses when working near sharp sheet metal or springs