Parts for Weedeater FEATHERLITE XT25: Weed Eater Parts

57-inch flexible drive shaft for brush cutters and line trimmers. Replaces worn, damaged, or broken flex shafts that transfer power from engine to cutting head.

Assembly screw for grass line trimmers, leaf blowers, and pruners. Secures internal components and housing panels. Replace if stripped, missing, or damaged.

This trigger, used by Poulan and Weed Eater trimmers and edgers, controls the flow of gasoline into the carburetor so as to increase or decrease the speed of the rotating trimmer twine. The trigger is attached to the trimmer's throttle cable assembly. Though designed and used specifically by Weed Eater and Poulan, more than 85 different gasoline-powered devices use this trigger to regulate gas flow. While made of rugged plastic, the throttle trigger is often susceptible to more wear and tear than almost any other part of the trimmer. It sticks out away from the body of the device and thus is most susceptible. Being constantly squeezed, banged into other pieces of equipment, cement sidewalks, trees, landscaping barriers, and the like, throttle triggers can become bent, broken or irreparably disconnected from the throttle of the yard tool. Replacing the trigger begins with draining fuel from the trimmer's tank, then removing the throttle housing. Remove the throttle cable from the old trigger and install it in the new trigger. Replace the throttle housing. When replacing the trigger, it's best to use a genuine OEM replacement part, like this one, machined to be identical to the original.

This handle is a genuine Husqvarna part. It is also sometimes called a throttle housing. It is manufactured as a replacement part for weed wackers, trimmers, and line trimmers. It is not uncommon for the handle to become worn over time, especially under heavy or frequent use. It will be visibly worn and uncomfortable to grip.To make this repair, empty the fuel tank, disconnect the spark plug, and let the engine cool completely. The handle is attached by screws. Remove the screws to separate the two halves of the handle. The spring, throttle control trigger, and throttle cable will need to be removed in order to disconnect the other half of the handle and fully replace it.This is a genuine OEM part sourced directly from the manufacturer. It is sold individually so consider whether both sides need to be replaced. It is compatible with machines made by Craftsman, Husqvarna, Poulan, and Weed Eater.

Replacement D-handle nut for brush cutters and trimmers. Secures the D-handle to the shaft assembly. Replace if stripped, cracked, or missing.

Trimmer cutting head for gas line trimmers. Replace if the head is cracked, damaged, or won't hold line properly. Installs at the bottom of the shaft.

String won't feed or trimmer cuts unevenly? This trimmer head houses and dispenses cutting line for precise grass trimming. Direct-fit replacement part.

String won't feed or trimmer head doesn't spin? This hub connects the trimmer line spool to the drive shaft, enabling proper string deployment and cutting.