White Westinghouse Freezer Parts

Used to hold the original electrical components to the side of the compressor.

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary

Foam insulation sleeve that wraps around the defrost drain tube. Replace if worn, missing, or damaged to prevent condensation and maintain proper insulation.

White access panel for chest and freestanding freezers. Covers internal components and provides service access. Replace if cracked, discolored, or missing.

This is the inner door panel that mounts on the inside surface of a freezer or refrigerator door. It provides structural support for door shelves and bins and helps maintain an insulated seal when the door is closed. Replace this panel if it is cracked, warped, or damaged, which can lead to poor insulation and temperature issues.

Replace your freezer's main wire harness if damaged, frayed, or showing exposed wires. Connects electrical components throughout the unit's interior.

Hinge side breaker trim for chest and freestanding freezers. Replaces cracked, broken, or missing trim pieces along the hinge edge of your freezer lid.

Replacement control housing cover for freezers. Snaps over the control panel assembly. Replace if cracked, broken, or missing to restore appearance.

Replace a damaged or frayed main wire harness in your freezer. This internal wiring assembly connects electrical components throughout the unit.

Rubber grommet for freezers. Cushions and seals components where wires or tubes pass through panels. Replace if cracked, worn, or missing.