Whirlpool WP90767 Screw OEM Part

One day my wife went to bake something and the bake/broil buttons as well as #3, #9, and oven light ceased to work. Local repair guy came by and wanted to charge $500 to fix it....YEAH RIGHT! Did a little homework and found this website, spoke with knowledgable staff who pointed me in the right direction. Took me all of about 20 minutes to install new control panel..everything works perfect...THANKS! p.s. In doing my research come to find Maytag did little to insulate control panel from oven heat and that using the "oven clean" function can cause so much heat it damages the internals of control panel...figures as I remember my wife using the cleaning mode for the first time not long before everything went haywire. Suggest you stay away from that mode and just be careful when in broil mode as well...

I ordered replacement parts to convert the side to individual burners.

At first i just bought the belt, started dryer and off came the belt, and yes it was in place,looking at the idler arm it had a lot off back and forth movement so i ordered the whole assembly but the spring which no one has.put it all together again but drum barely turned.. so back apart and belt was in place. took the idler spring out cut 4 loops off it re did the end so it would hook on idler arm.and that did the trick.runs like new.

Between YouTube, a multimeter and Appliance Parts Pro I was able to diagnose the problem and fix the oven without an expensive service call.

Ordered parts for a 25 year old Maytag gas dryer..no problem in getting parts,.the web site for parts are great It cross references to other parts so you can order the parts. or suggestion on what you may need to do..I didn't have to take the dryer totally apart from the front..as if you would repair the drum roller for which I did a few time ..just pull out dryer from wall disconnect the gas and power suppley..open the small 8 x8 panal on backside where the motor is located , take old parts out replace will new parts down. reconnect everything..Than done ..It took me 20 to 25 minutes to do the job..My skill level is very good. If I would get a repairs person to do it. I would have to take the dryer to than and the cost would be over $200. Besides if you have anything that more than10 years old no one will repair it. So I save over $!00.. By doing it myself