R. P Shorewood , WI July 09, 2016 Appliance: KitchenAid 6 Qt. Stand Mixer Epicurean Bowl Lift KT2651XWW3 Speed control knob broken off board assembly of a kitchenaid epicurian mixer I purchased a replacement assembly from Appliancepartspluspro.com Upon inspection of new part I noticed there were only 6 terminals for the 8 wires I needed to connect. After much investigation by their tech support person Ali, it became apparent that my old part was discontinued and no longer available. The new part was the correct replacement but now I had to figure out what to do with the 2 extra wires. I labeled all of the wires and the terminals on the the old part. After moving wires, one by one, to the new board I was left with P1 and a wire from a micro switch. Obviously the switch was no longer functional with the new board. As for P1 I surmised it was no longer needed due to updates to the circuitry on the new board. Checked all connections and fired the mixer up. Voila !!! It worked perfectly at all speeds for over an hour. I left the obsolete P1 and micro switch tucked away inside the mixer head just to be safe. Special thanks to Ali for his patience and determination in solving my dilemma. Read More... 16 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Michael D Clinton , AR January 06, 2022 Noisy. Not working right. Replace bearings etc. Only one part didn’t fit so I used the old. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Nut Drivers, Screwdrivers
Brooks G Mukilteo , WA August 01, 2022 Appliance: KitchenAid 6 Quart Professional 600 Bowl Lift Stand Mixer KP26M1XER5 Worn gears. I replaced the Gear kit. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers