Anthony C Westminster , CO November 26, 2014 Appliance: KitchenAid 7 Qt. Stand Mixer KSM7581CA0 Intermittent speed control on kitchenaid 7qt stand mixer Unplug the unit from power. Remove decorative aluminum band from motor enclosure by removing single screw at rear of mixer. Remove screws (now exposed) which secure the top half of the motor enclosure. Using a 1/8" punch, tap-out the pin that penetrates the planetary gear cover and the motor shaft (takes some finesse to avoid damage to the painted/coated planetary. It is a tight fit!) This will allow the planetary gear and cover to drop. Now the motor and gear unit can be removed. Do so by removing the Phillips-head screws securing the motor/gear unit. Remove the Phillips-head screws securing the speed-control circuit board. Free it up to be able to access the bottom of the board (to unplug wiring). Now, disconnect the wiring that connects the speed control circuit board from the motor and remove the defective board/speed control. Connect wiring for the NEW circuit board to the motor unit, and re-attach both the board and the motor into place using the appropriate screws. Insert the planetary gear unit back on the motor shaft. Line up the holes for the pin and carefully tap the pin back into place. Replace the top of the motor enclosure and the decorative trim piece. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Randy L Chambersburg , PA August 04, 2016 Kitchen aid stand mixer needed some repairs and i decided to change some other parts while doing it Basic open it up and swap parts need a special pliers for clip rings but can make do with others easy enough Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers
Craig L Hailey , ID June 23, 2019 Appliance: Model KITCHENAID 8QT STAND MIXER Speed control was erratic some 'dead spots' on control. Replaced board for speed control. Fairly easy. look @ exploded view helped. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Rodney A Richmond , VA December 07, 2020 Kitchenaid mixer would not start until it turned to level 6. I replaced the control board and it now works correctly. It will start at level 2 and progress in speed as the speed lever is moved upwards. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Patrick C Keene , NH January 09, 2020 Appliance: KitchenAid 8 Qt. Stand Mixer Commercial - Bowl Lift KSM8990OB0 Mixer did not function at all speeds I removed the cover, disconnected all the power connections to the motor, removed the planetary, removed the motor, replaced the speed control, cleaned and lubricated the planetary and reassembled. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers