Kevin S Eufaula , OK September 13, 2020 Appliance: KitchenAid 6 Qt. Stand Mixer Professional 620 Bowl Lift KP26M8XCP5 Mixer was starting to run rough, squeaky, needed gears replaced. Watched videos available on APP's website, then ordered all necessary parts. Once parts arrived, just followed the videos again, step-by-step, to repair the mixer. I am NOT a "handyman", but with APP as my resource, I did it. Mixer running great now. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers
Randy L Chambersburg , PA August 04, 2016 Kitchen aid stand mixer needed some repairs and i decided to change some other parts while doing it Basic open it up and swap parts need a special pliers for clip rings but can make do with others easy enough Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers
Robert H Ocala , FL March 11, 2015 The mixer sheared a pin and damaged thr mixer drive shaft I was able to order the replacement parts. The person I talked to when ordering the parts was very helpful and pleasant to work with Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Carl H Mesa , AZ December 31, 2018 Gear box making a thump noise Replaced the stationary gear and the agitator gear, shaft, bushing, oring, and repacked the grease. Works good now. Stationary gear was the most difficult due to the tight fit. Start it straight and work it in slowly(small movement on each side. Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers
Peter B Olalla , WA June 23, 2019 Appliance: Model KP2671XWH During mixing the mixing tool stopped turning I took the KitchenAid mixer apart until I found the broken part. The only slightly difficult part is removing a circlip - with a circlip removal tool, the repair was easy. After replacing the Dowel Pin and reassembling the mixer, it works great! Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers