Paul H Tyngsboro , MA October 20, 2014 The touch panel on the front of my jennair range stated to malfunction I purchased the part (which unfortunately included the whole front metal panel) from ApplianceParts.com It arrived quickly. I looked it over - 6 screws. I switched off the power to the range and quickly removed the 6 screws from the panel. Unfortunately, the panel was connected inside to a circuit board which was attached to the back of the metal front. I removed the 4 screws holding the circuit board and removed the old metal panel and touch panel. I reconnected the new touch panel to the old circuit board. Then screwed the old circuit board onto the back of the new panel. I put back the 6 screws and reset the power - everything worked fine!! Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Harry A Newark , OH October 31, 2015 Appliance: Maytag 30" Modular Gas Downdraft Range JDS9860BDB21 Oven would not work nor could the clock time be set Replaced the front panel of the stove with the number pad. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Greg A Los Angeles , CA March 17, 2017 Several buttons stopped functioning on the control panel I replaced the touch panel on the range as well as the door gasket, since it was suggested that leaking heat from the door can damage the panel above it. Did it all in 15 minutes, no sweat. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
William T Corpus Christi , TX December 06, 2017 Appliance: Maytag 30" Modular Gas Downdraft Range JDS9860BDB21 No control over any electric function no response from any touch pad buttons Replaced front panel with new touch pad. Read More... Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Screwdrivers
Keith J Eugene , OR January 11, 2020 Appliance: Maytag 30" Modular Gas Downdraft Range JDS9860BDB21 We have a Jenn Air dual fuel downdraft range and few functions on the control panel stopped working. I replaced the control panel with a new one from AppliancePartsPros, PN: WPW102. It took about 15 minutes and was pretty straight forward. FIRST; I removed power to the range...Then, there are a total of 14 screws that need to be removed, 1 on each side, 4 on the bottom of the panel, 4 on the front (1 under each knob) and 4 holding the circuit board in. Prior to removing the last 4 screws holding the circuit board, I unplugged the ribbon connector that is attached from the control panel to the circuit board. Afterwards just reversed the process to install the new part. Overall it was a lot easier the I thought it would be. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers