Troy P Newnan , GA April 21, 2014 Appliance: Maytag Slide-In Electric Range JES9750BAB17 I have a jenn air jes9750bab the buttons on the touch pad went out i wasn't sure if it was this part or the display panel that was broken Replaced the part with this front panel with the buttons and the range works. I won't be broiling with the door open ever again. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Robert G Kalkaska , MI July 13, 2019 Appliance: Maytag Slide-In Electric Range JES9750BAB17 The touch pad quit working On my Jennaire JES9750, the touchpad is built into the front panel where the top burner knobs are located. I purchased the panel, removed 4 screws from the bottom of the panel, 1 screw from each side, remove 4 burner control, 2 screws each, removed the control panel, several color-coded plugs, and 4 screws. installed all in the new panel and reinstalled panel. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Joe C Halfway , OR November 10, 2014 Unable to use or set the oven or the clock Replaced the Control Panel, and everything was fully operational! Great assistance with the diagnosis from APP folks, in their forums. Be careful removing the wire connections to the stove burner indicator bulbs, but an easy task. Everything comes apart easily, nothing needs to be forced. Find the screw that hold it together: one on each end, and several underneath. Slide the whole unit out from the counter set-in to access the end screws. Overall a little tedious, but not hard. And certainly more efficient than calling a service person. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Lynn A Bedford , IN August 03, 2014 Appliance: Maytag Slide-In Electric Range JES9750BAB17 The touchpad display stopped working on my jenn air jes9750bab downdraft range I ordered the panl-cntrl from Appliance Parts Pros. It was a pretty easy job to install the new panl-Cntrl which solved the problem. Only problem I had was taking the two side screws out of the panl-cntrl. I didn't have the clearance to get a screwdriver on the screw but finally used a socket wrench with with a screwdriver attachment. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set
Jack M Blanchard , ID October 17, 2015 Touch pad on my jenn air range went out after running a self clean! Replaced the touch pad module. Took about 15 minutes. Works like a charm now. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers