Jim J Prosser , WA March 12, 2014 Washer would not let cold water into the machine. I tested the Atc. mid level switch, with my multi tester and found it was not sending enough current to the cold water inlet valve, so it would not open and let cold water in. I replaced the switch, (it was a snap) literally it snapped in place. replace the front face and turned the water back on and plugged in the washer, and turned it on. It worked perfect and has been since. good and easy repair even for a novice like me.. Read More... 15 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers
Chris G Jefferson , TX July 25, 2015 Appliance: Model ROPER RTW4440VQ1 My cold water wouldn't come on I googled the problem and it was either the water inlets or the water temp. switch. I replace the water inlet, no good yet, my old one was bad, the cold side coil had heated up and the circuit was bad. Then I replace the water temp control. It works like new. It was very easy to do and the parts were right, about half of the local parts store and shipping was very fast and postage very cheap or none at all. Probably saved $150. dollars in labor and parts. The washer was too nice to scrap. Read More... 8 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Adjustable Wrench, Pliers, Screwdrivers
Lesley T Panama City Beach , FL February 26, 2015 Hot/cold water control switch Replaced it.Thank you for being there and having the item I needed available. Read More... 4 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Nut Drivers, Screwdrivers
Vincent S Broken Arrow , OK October 16, 2021 Appliance: Whirlpool Washer WTW5200VQ2 We have either hot or cold, but no warm water intermittently. Suspected either thermistor defective or the temperature controller. Neither could be conclusively confirmed as accurate so I replaced the temperature switch and valve assembly with thermistor. Things are working as expected now. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Nut Drivers, Pliers
Bruce M Janesville , WI February 04, 2017 Water temperature switch had a lot of water hammering the switch did not know what water temperature to pick Put in a new switch no more hammering very fast delivery video on website on how to do the fix Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers